Results 101 to 110 of about 10,603,586 (233)
An overview of the 2H NMR application shows how to use the DQCC values in metal–hydrogen systems for characterization of metal–hydrogen bonding modes in transition metal hydride complexes, metal–hydrogen alloys, metal nanoparticles, and immobilized metal hydrides.
Vladimir I. Bakhmutov
wiley +1 more source
The study aims to investigate the impact of uniform, grooving and non-uniform corrosion degradation on the hot-spot stresses of a T-shaped tubular joint using the finite element method.
Lingsu Liu +6 more
doaj +1 more source
Overprinting filament from recycled composites with surface treatment for flat substrate and curved substrate. ABSTRACT This study presents a sustainable 3D overprinting approach for recycling of discontinuous carbon fibers from both thermoset and thermoplastic composites, incorporating a stable fiber surface treatment with polydopamine/silica ...
Yahui Lyu +4 more
wiley +1 more source
Hot spot along corner curvature of rectangular plate opening [PDF]
Development of stress concentration in the corner zone of rectangular plate opening is a well-known fact. It is usually literally taken that the largest stress concentration factor (SCF) occurs exactly in the corner (at angle coordinate of 45 degrees in ...
Momčilović Nikola +2 more
doaj
ANALYSIS AND MODIFICATION OF ISOTROPIC/ORTHOTROPIC PLATE WITH CENTRAL ELLIPTICAL HOLE SUBJECTED TO IN-PLANE STATIC LOADING FOR REDUCTION OF STRESS CONCENTRATION FACTOR [PDF]
The stress distribution in isotropic/orthotropic plates with different discontinuities under in-plane static loading has been studied widely. In present paper plate with elliptical hole under in-plane loading has been considered for analysis.
Shubhrata Nagpal +2 more
core
Tribological Behavior of Additively Manufactured Dual‐Material Polymer Composites
Layered architecture, tribological performance, and wear mechanisms of additively manufactured dual‐material hybrid polymer composites. ABSTRACT This study presents a novel material design approach for wear‐resistant sandwich‐structured hybrid composites fabricated using dual‐nozzle fused deposition modeling (FDM). By co‐printing commercially available
Zhiwang Li +3 more
wiley +1 more source
The stress concentration factor (SCF) is one of the most important parameters in the fatigue reliability analysis of steel offshore structures. This parameter exhibits considerable scatter which calls for greater emphasis in accurately computing the SCFs
Lotfollahi-Yaghin, Mohammad Ali +3 more
core +1 more source
Spatial Statistics for Screening Molecular Structures
Deep architectures for materials discovery demand vast training data and obscure the structure‐property link. This review shows how spatial statistics offer a physically grounded alternative: voxelized fields and two‐point correlations, compressed by principal component analysis, yield convex, interpretable descriptors. Lean surrogates then reach sub‐2%
Pranoy Ray, Surya R. Kalidindi
wiley +1 more source
FcεRI cross‐linking triggers widespread transcriptional reprogramming in human skin mast cells (> 5000 genes, > 6400 promoters, and 48 novel mast cell‐enriched lncRNAs). Breast skin and foreskin mast cells share core transcriptional programs but differ selectively in tryptase isoenzymes and IL‐8/IL‐1RA release.
Gürkan Bal +12 more
wiley +1 more source
Low‐affinity Ag–IgE interactions enable effective FcεRI internalization through the formation of small receptor clusters, promoting MC desensitization without triggering unintended degranulation. This low‐affinity stimulation restricts unintended MC activation and attenuates the risk of systemic anaphylaxis in vivo. Differential MC susceptibility to Ag–
Yuka Nagata +5 more
wiley +1 more source

