Results 91 to 100 of about 1,733 (215)
PERANCANGAN PILE CAP DENGAN METODE “STRUT AND TIE MODEL” [PDF]
, 2012 Pile cap adalah struktur yang berfungsi untuk menyatukan kelompok tiang pancang dan menyalurkan beban dari kolom menuju kelompok tiang pancang. Penyaluran beban dari kolom menuju tiang pancang menyebabkan terjadinya konsentrasi tegangan dan regangan ...
Purba, Dytha Eryanth
core
Experimental Verification of Strut and Tie Model Design Method [PDF]
ACI Structural Journal, 2007 Although strut-and-tie models (STM) appear to provide safe, lower-bound designs for irregular concrete members, there have not been many experimental validations of them. This paper presents the result from two series of testing of STM specimens. In the first series, 6 specimens having different reinforcing designs but the same overall geometry and ...
openaire +1 more source
Enhanced strut-and-tie model for reinforced concrete pile caps
, 2017 Strut-and-tie models provide a simple and rational way to design discontinuity regions in reinforced concrete structures. However, when it comes to three-dimensional concrete elements such as pile caps, enhancements are needed to ensure a reliable and ...
Rempling, Rasmus +5 more
core
ISEC 4: Innovations in Structural Engineering and Construction [PDF]
, 2008 This paper presents the performance-based optimization of strut-and-tie models in reinforced concrete deep beams. The performance-based optimization (PBO) technique combines performance-based design concepts with modern topology optimization technologies
Ng, A. W. M., Liang, Q. Q.
core +1 more source
Effect of loading type in concrete deep beam with strut reinforcement
Open EngineeringThis study examined eight specimens of two groups of deep beam (DB) with the same dimensions and reinforcement quantity, where the first group had four specimens tested under two-point loads and the second group had four specimens tested under one-point ...
Kadhim Hussein Kamal +1 more
doaj +1 more source
, 2011 In this study, the ultimate strength of 234 simply supported reinforced concrete deep beams tested to shear failure was evaluated by the ACI 318M-08's strut-tie model approach implemented with the indeterminate strut-tie model and load distribution ...
Young-Mook Yun, Byung-Hun Kim
core +1 more source
Analysis of the structural behavior of beam-column joints in reinforced concrete frames considering bending towards the reduced side of the cross section [PDF]
Revista IBRACON de Estruturas e MateriaisThe beam-column joints are called discontinuous regions and, therefore, could be designed by the strut and tie method. In beam-column joints where the bending plane coincides with the column's smaller dimension, the bending moments associated with the ...
Carolina Grossi de Paiva +4 more
doaj +1 more source
Utilizing the Strut-and-Tie Model for the Design and Analysis of Deep Beams
Modelling in Civil Environmental EngineeringReinforced concrete deep beams, distinguished by a low shear span-to-depth ratio, exhibit complex, nonlinear strain distributions that render conventional beam theory inadequate.
Platon Mihai
doaj +1 more source
Analysis and design of disturbed regions with strut-tie models
, 1992 An interactive computer graphics program implementing the Strut-Tie model approach for analysis and design of reinforced and prestressed concrete members is presented. The program consists of three parts.
Alshegeir, Abdulsallam A
core +1 more source
Strut Method for the Analysis of Confined Masonry Structure with Opening
Electronic Journal of Structural EngineeringConfined masonry construction (CM) is an efficient earthquake-resistant structural system that consist of masonry walls as the main structure and RC tie column and beam as confining elements.
Ida Ayu Made Budiwati +2 more
doaj