Results 81 to 90 of about 2,512,899 (272)
Sub-Nyquist pulse Doppler radar system has received wide attention recently because it can make the sampling rate lower than the Nyquist sampling rate. However, there are still two problems that must be addressed for sub-Nyquist pulse Doppler radar.
Beiyi Liu +4 more
doaj +1 more source
Polymer binders and thick pressed LLZTO pellets limit all‐solid‐state battery integration through grain‐boundary carbon and high ohmic losses. A binder‐free capillary suspension ink is direct‐ink‐written and sintered into 254 μm$\mu{\rm m}$, 95.8%‐dense Ta‐stabilized LLZTO with 17.3 mS cm−1$\text{cm}^{-1}$ bulk conductivity, enabling thinner ...
Sri Vaishnavi Thummalapalli +7 more
wiley +1 more source
Life‐Like Ferrous Oxide Microspheres from Kombucha
Kombucha bacterial cellulose, sodium alginate, and ferrous nitrate self‐assemble into membrane‐enclosed iron oxide microspheres. These microspheres bud daughter vesicles, sustain 24‐h electrochemical oscillations, and filter theta‐band signals.
Panagiotis Mougkogiannis +2 more
wiley +1 more source
Sub-Nyquist Cyclostationary Detection of GFDM for Wideband Spectrum Sensing
Spectrum scarcity is a challenging problem in wireless communications: high data rates are needed to support 5G new technologies. However, the spectrum is underutilized.
Noura A. El-Alfi +2 more
doaj +1 more source
A signal reconstruction method of wireless sensor network based on compressed sensing
Compressed sensing (CS) is a new theory for sampling and recovering signal-based sparse transformation. This theory could help us to acquire complete signal at low cost.
Shiyu Zhu +4 more
doaj +1 more source
Study of sub-nyquist sampling and noise folding effect
Sub-Nyquist sampling, sampling below Nyquist rate, was introduced to reduce the computational load and storage space caused when adhering to the Nyquist-Shannon sampling theorem. Studies over the years resulted in different schemes to achieve sub-Nyquist
Sugunthan, T.
core
A sonochemical strategy constructs an ex situ 2D hierarchical black phosphorus–Mn2O3 heterostructure, enabling intimate interfacial coupling, enhanced charge transport, and improved electrochemical stability. The optimized BPM‐37.5% electrode delivers 466 F g−1 with 84% retention after 8000 cycles, while the flexible device exhibits high areal energy ...
Sowmiya Selvaraj +1 more
wiley +1 more source
Bilayered PEDOT:PSS–Collagen Scaffolds as Functional Architectures for Tissue Engineering
A bilayered scaffold integrates collagen and PEDOT:PSS as distinct yet interconnected 3D matrices, preserving their fibrillar and conductive characteristics. Spatial compartmentalization enables independent tailoring of each domain while maintaining mechanical stability and compatibility with electrochemical monitoring, providing a multifunctional ...
Rasha Nasser +6 more
wiley +1 more source
Sub-Nyquist computational ghost imaging with deep learning
We propose a deep learning computational ghost imaging (CGI) scheme to achieve sub-Nyquist and high-quality image reconstruction. Unlike the second-order-correlation CGI and compressive-sensing CGI, which use lots of illumination patterns and a one-dimensional (1-D) light intensity sequence (LIS) for image reconstruction, a deep neural network (DAttNet)
Heng Wu +8 more
openaire +2 more sources
Conformal Coating and Transfer of 2D Nanomaterials via Dynamic Interface Engineering
This review discusses conformal coating and transfer of two‐dimensional (2D) nanomaterials with a focus on dynamic interface engineering. By actively regulating nanosheet transport and interfacial contact during film formation, recent dynamic coating strategies overcome the limitations of conventional passive approaches and enable geometry‐adaptive ...
Seungyeon Kim +4 more
wiley +1 more source

