Results 91 to 100 of about 34,329 (324)
Boiling incipience and convective boiling of neon and nitrogen [PDF]
Forced convection and subcooled boiling heat transfer data for liquid nitrogen and liquid neon were obtained in support of a design study for a 30 tesla cryomagnet cooled by forced convection of liquid neon.
Hendricks, R. C., Papell, S. S.
core +1 more source
Assessment of CTF boiling transition and critical heat flux modeling capabilities using the OECD/NRC BFBT and PSBT benchmark databases [PDF]
, 2011 The need to refine models for best-estimate calculations, based on good-quality experimental data, has been expressed in many recent meetings in the field of nuclear applications.
Avramova, Maria, Cuervo Gómez, Diana
core +1 more source
Phase appearance or disappearance in two-phase flows [PDF]
, 2011 This paper is devoted to the treatment of specific numerical problems which appear when phase appearance or disappearance occurs in models of two-phase flows. Such models have crucial importance in many industrial areas such as nuclear power plant safety
A Guelfi +32 more
core +2 more sources
Journal of Thermal Science and Technology, 2013 For predicting the void fraction distribution in subcooled flow boiling, it is necessary to measure the interfacial heat transfer coefficient—which determines the amount of condensation rate of vapor bubble—with high accuracy.
Noriaki INABA +2 more
doaj +1 more source
Influence of heat input waveform on transient critical heat flux of subcooled water flow boiling in a short vertical tube [PDF]
, 2010 The transient critical heat fluxes (CHFs) of the subcooled water flow boiling for ramp-wise heat input [Q = αt, α = 6.21 × 108 to 1.63 × 1012 W/m3 s, (q 1.08 × 107 to 6.00 × 107 W/m2)] and stepwise one [Q = Qs, Qs = 0 W/m3 at t = 0 s and Qs = 2.95 × 1010
Hata, Koichi, Masuzaki, s.
core +1 more source
Advances in Mechanical Engineering, 2015 The axial heat transfer coefficient during flow boiling of n -hexane was measured using infrared thermography to determine the axial wall temperature in three geometrically similar annular gaps with different widths ( s = 1.5 mm, s = 1 mm, s = 0.5 mm).
Gunar Boye +2 more
doaj +1 more source
Flow of vapour in a liquid enclosure [PDF]
, 1976 A solution is developed for the flow of a vapour in a liquid enclosure in which different portions of the liquid wall have different temperatures. It is shown that the vapour pressure is very nearly uniform in the enclosure, and an expression for the net
Plesset, Milton S., Prosperetti, Andrea
core +1 more source
Numerical simulation of subcooled boiling in a vertical pipe with twisted tape inserts [PDF]
مجله علوم و فنون هستهای, 2015 Subcooled flow boiling occurs in many industrial applications and it is characterized by a large heat transfer coefficient. In this paper, numerical simulation of subcooled flow boiling in a vertical pipe is investigated by ANSYS CFX 14.
Hossein Kazeminejad, Mehdi Tafreshi
doaj
Quench cooling under reduced gravity
, 2013 We report the quench cooling experiments performed with liquid O2 under different levels of gravity simulated with the magnetic gravity compensation. A copper disk is quenched from 270K to 90K.
Beysens, D. +3 more
core +3 more sources
Two-Phase Pipe Flow in Microgravity with and without Phase Change: recent progress and future prospects [PDF]
, 2015 Gas-liquid and liquid-vapor pipe flows in microgravity have been studied for more than forty years because of theirpotential applications in space industries for thermal control of satellites, propellant supply for launchers, and wastewater treatment for
Colin, Catherine, Narcy, Marine
core +2 more sources