Results 91 to 100 of about 13,244 (210)
Open-Source Software Architecture for Multi-Robot Wire Arc Additive Manufacturing (WAAM) [PDF]
arXivWire Arc Additive Manufacturing (WAAM) is a metal 3D printing technology that deposits molten metal wire on a substrate to form desired geometries. Articulated robot arms are commonly used in WAAM to produce complex geometric shapes. However, they mostly rely on proprietary robot and weld control software that limits process tuning and customization ...
arxiv
The FN Process-A New Submerged-Arc Welding Process to Improve Toughness of Weld Metal (Report 1)
, 1964 Tomomichi Hotta +4 more
openalex +2 more sources
Study on Submerged Arc Welding for HT-80 Steel
, 1963 Toshiro Yoshida +3 more
openalex +2 more sources
Minería y Geología, 2018 The production of chromium manganese ferroalloys for the use in the development of alloying loads of welding consumables is presented. On the basis of variations in the proportions of the chromium and manganese minerals in the loads, different ...
Lorenzo Perdomo-González +3 more
doaj
Study of Submerged-Arc Welding by Bonded Fluxes (2nd Report)
, 1963 俊景 一海, 文則 渡辺
openalex +2 more sources
Submerged Arc Welding of Steel for Low-Temperature Service in USSR
, 1963 Tetsugoro Muramoto
openalex +2 more sources
The influence of heat treatment by annealing on clad plates residual stresses
Metalurgija, 2011 The influence of applied clad procedure as well as heat treatment by annealing (650 °C/2h) on level and nature of residual stresses was researched. Three clad procedures are used i.e.
B. Mateša +3 more
doaj
Comparison of Microstructure and Mechanical Properties of Ultra-Narrow Gap Metal Active Gas Arc Welded and Narrow Gap Submerged Arc Welded Q235A Low Carbon Steel. [PDF]
Materials (Basel), 2023 Wu S, Xiao W, Gong L, Zhang F.
europepmc +1 more source
Submerged-Arc Welding of Ni and Ni Alloys in U.S.S.R.
, 1963 Tetsugoro Muramoto
openalex +2 more sources