Results 111 to 120 of about 130,677 (247)

Advances in MoS2‐Au Nanostructured Platforms for Cancer‐Derived miRNA Detection

Advanced Materials Interfaces, EarlyView.
This figure presents the roadmap and scope of this review on microRNA detection technologies, with emphasis on MoS2 and MoS2–Au hybrid nanostructures. It traces the evolution from conventional assays to MoS2‐based SERS platforms, highlights synthesis, interfacial chemistry, and signal‐enhancement mechanisms, and summarizes key challenges and future ...
Faith Mokobi Zablon, Kristen Dellinger, Shyam Aravamudhan   +2 more
wiley   +1 more source

Construction of a Cu/Fe/S multi-active-site synergistic Fenton-like system <i>via</i> mechanically activated natural copper sulfide ore for efficient tetracycline degradation. [PDF]

RSC Adv
Gou L, Miao X, Liu Y, Zhang M, Guo M.
europepmc   +1 more source

RF Magnetron Sputtered Tungsten Disulfide Films: Influence of Target Preparation, Deposition Parameters, and Storage Conditions on Thin Film Stoichiometry

Advanced Materials Interfaces, EarlyView.
Sputtered WS2 films were investigated in terms of their S‐ and O‐concentration depending on deposition power and pre‐sputter time. Chemical and structural investigations were done using EDS, TEM, SEM, AFM, XRD. In general, 20 W films exhibit a wide variation in stoichiometry and structure whereas 80 W films demonstrate a higher S/W ratio than 20 W ...
Theresa Scheler, Pascal Illgner, Thomas Kups, Michaela Blum, Peter Schaaf   +4 more
wiley   +1 more source

NIR‐Activated Ag2S Quantum Dots for Efficient Broad‐Spectrum Antibacterial and Biofilm Disruption

Advanced Materials Interfaces, EarlyView.
This study presents a novel non‐antibiotic strategy leveraging NIR‐activated Ag2S QDs for synergistic PTT/PDT. The platform degrades the protective extracellular matrix via localized hyperthermia, facilitating deep penetration and ROS‐induced oxidative damage.
Rui Yao, Peiqing Sun, Yaxin Chen, Zhijie Lei, Li Wang, Jianglin Yu, Ying Liu, Wusimanjiang Hailipitimu, Wei Wei, Jing Zhao, Xusheng Qiu   +10 more
wiley   +1 more source

Development and Application of a 3D-Printed Microfluidic Sulfide-Selective Sensor for Online Monitoring of a Hydrogenotrophic Sulfidogenic Bioreactor. [PDF]

Nanomaterials (Basel)
Cueto D, Baeza JA, Gabriel D, Baeza M.
europepmc   +1 more source

Flow‐Adaptive Gas Sensing Enabled Using a Uniform Au Nanosheet Sensor Array and a Neural Network Inference

Advanced Materials Technologies, EarlyView.
Integrated Au nanosheet sensor array enables simultaneous inference of gas concentration and flow rate via deep neural network analysis, without external flow control. ABSTRACT Gas sensor responses are considerably affected by gas flow rates, thereby inhibiting the accurate detection of target gas concentrations in variable‐flow applications such as ...
Taro Kato, Takahisa Tanaka, Yusuke Hamanaka, Ryo Toyoshima, Ken Uchida   +4 more
wiley   +1 more source

Photocatalytic degradation of dyes by metal sulfide-chitosan based composites: a comprehensive review. [PDF]

RSC Adv
Arif M.
europepmc   +1 more source

Amido‐Amine Co(II) Precursor‐Based Atomic/Molecular Layer Deposition Processes for Cobalt‐Organic Thin Films and Their Thermal Conversion to CoO Thin Films

Advanced Materials Technologies, EarlyView.
Three new atomic/molecular layer deposition processes are developed for Co‐organic thin films using a promising all‐nitrogen‐coordinated cobalt precursor. The study examines film growth, reaction mechanisms, chemical stability, and decomposition pathways of the resulting films through extensive characterization techniques and DFT calculations ...
Topias Jussila, Jorit Obenlüneschloß, Ji Liu, Olga Partanen, Sami Vasala, Detlef Rogalla, Pieter Glatzel, Michael Nolan, Anjana Devi, Maarit Karppinen   +9 more
wiley   +1 more source

Exploring stacking pressure-induced mechanical failure of a Ni-rich cathode in sulfide solid-state batteries. [PDF]

Chem Sci
Feng Y, Wang Z, Luo G, Deng D, Peng W, Zhang W, Duan H, Wu F, Ou X, Zheng J, Wang J.   +10 more
europepmc   +1 more source

Three‐Dimensional Printed Microarchitected Hierarchically Porous Biodegradable PLA/S/CNT Nanocomposite Electrodes for High‐Performance Lithium–Sulfur Batteries

Advanced Materials Technologies, EarlyView.
Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta, Pawan Verma, Fahad Alam, Krishnaiahnahundi Manjunathaswamy Mohan, Shanumgam Kumar   +4 more
wiley   +1 more source