Results 51 to 60 of about 1,345,804 (321)
The effect of tube diameter on vertical two-phase flow regimes in small tubes [PDF]
, 2006 Flow boiling flow patterns in four circular tubes with internal diameters of 1.10, 2.01, 2.88 and 4.26 mm were investigated in the present project. The experiments were conducted in vertical upward two-phase flow using R134a as the working fluid.
Chen, L, Karayiannis, TG, Tian, YS
core
Canaloplasty in the Treatment of Open-Angle Glaucoma: A Review of Patient Selection and Outcomes. [PDF]
, 2018 Canaloplasty is a relatively new non-penetrating surgery for the reduction of intraocular pressure in patients affected by glaucoma. The technique uses a microcatheter to perform a 360 º cannulation of Schlemm's canal and leaves in place a tension suture
Brusini, Paolo +5 more
core +2 more sources
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Engenharia Agrícola, 2007 O trabalho teve como objetivo avaliar a tensão superficial estática de soluções aquosas com formulações de óleos minerais e vegetais emulsionáveis utilizados como adjuvantes na agricultura.
Cristina G. de Mendonça +2 more
doaj +1 more source
Hydrodynamic and mass transfer in inertial gas–liquid flow regimes through straight and meandering millimetric square channels [PDF]
, 2011 Heat-exchanger reactors are an important part of process intensification technology. For plate geometries, one solution for intensifying transfer and increasing residence times is to construct two-dimensional meandering channels.
Cabassud, Michel +3 more
core +3 more sources
Advanced Functional Materials, EarlyView.Biofabrication aims at providing innovative technologies and tools for the fabrication of tissue‐like constructs for tissue engineering and regenerative medicine applications. By integrating multiple biofabrication technologies, such as 3D (bio) printing with fiber fabrication methods, it would be more realistic to reconstruct native tissue's ...
Waseem Kitana +2 more
wiley +1 more source
Diagnostic value of macular blood flow in normal tension glaucoma [PDF]
Клиническая офтальмология, 2023 A.Sh. Zagidullina1, V.U. Galimova1, A.I. Arslanova1,2, A.R. Nugmanova1 1Bashkir State Medical University, Ufa, Russian Federation 2City Clinical Hospital No.
A.Sh. Zagidullina +3 more
doaj
Effective Interventions for Treating Superficial Self Mutilators [PDF]
, 2008 Self-cutting is the most common form of self-mutilation in adolescents but there is insufficient knowledge as to which treatment methods to reduce self-mutilation are most effective.
Palladini, Maria
core +1 more source
Recognizing myofascial pelvic pain in the female patient with chronic pelvic pain. [PDF]
, 2012 Myofascial pelvic pain (MFPP) is a major component of chronic pelvic pain (CPP) and often is not properly identified by health care providers. The hallmark diagnostic indicator of MFPP is myofascial trigger points in the pelvic floor musculature that ...
Katzman, Wendy B, Pastore, Elizabeth A
core +1 more source
Reconfigurable Magnetic Soft Microrobot for Acoustically Triggered Targeted Bacterial Sterilization
Advanced Functional Materials, EarlyView.Reconfigurable magnetic soft microrobots integrate in situ‐grown piezoelectric zinc oxide nanorods that produce reactive oxygen species upon acoustic excitation. Combining magnetically guided transport with thermally induced planar reconfiguration, the microrobots achieve targeted delivery and enhanced bacterial sterilization through efficient on ...
Quan Gao +12 more
wiley +1 more source