Results 31 to 40 of about 457,397 (165)
Study on minimum flight speed airworthiness standard of supersonic civil aircraft
Supersonic civil aircraft has significant changes in aerodynamic layout and design compared to subsonic civil aircraft, which will bring new risks and make some provisions of the current regulations inapplicable.
YANG Jianzhong +2 more
doaj +1 more source
Hierarchical optimization method of supersonic low sonic boom configuration
Sonic boom suppression is a key technology that must be broken through in the development of a new generation of supersonic civil aircraft. The reasonable design of configuration parameters can make the aircraft have good sonic boom characteristics.
MA Chuang +4 more
doaj +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
To the issue of evaluating sonic boom overpressure and loudness [PDF]
At present, in the world there is a growing interest in the development of a new generation of supersonic passenger aircraft. One of the main problems of creating such aircraft is to ensure both an acceptable sonic boom level and high aerodynamic ...
Bashkirov Igor G. +5 more
doaj +1 more source
The pholidota‐inspired electronic skin is successfully constructed, originally realized four‐state reversible switching of terahertz‐wave reflection, absorption, transmission, and secondary reflection. In response to external demands, it issues deformation instructions, verifies the deformation state after the equipment executes the action, and thus ...
Shangjing Li +4 more
wiley +1 more source
The phase transition of supercritical CO2 induces the foaming of dense MXene film without compromise inherent structure of MXene nanosheet. The foamed porous MXene film manifests remarkable EMI shielding and infrared thermal camouflage performances. Moreover, the foaming strategy is broadly adaptable and can be extended to other two‐dimensional films ...
Hui Zhao +7 more
wiley +1 more source
Climate impact of supersonic air traffic: an approach to optimize a potential future supersonic fleet ─ results from the EU-project SCENIC [PDF]
The demand for intercontinental transportation is increasing and people are requesting short travel times, which supersonic air transportation would enable. However, besides noise and sonic boom issues, which we are not referring to in this investigation,
I.S.A. Isaksen +13 more
doaj
INVESTIGATION AND MODIFICATION OF AERODYNAMIC CHARACTERISTICS OF SUPERSONIC AIRCRAFT
Increasing the aerodynamic efficiency and enhancing the supermaneuverability for the selected supersonic aircraft (F-16A) is presented. Aerodynamic characteristics, surface pressure distribution and maximum lift are are estimated for the baseline ...
Jafar M. Hassan +2 more
doaj +1 more source
This study proposes a deep learning approach to evaluate the fatigue crack behavior in metals under overload conditions. Using digital image correlation to capture the strain near crack tips, convolutional neural networks classify crack states as normal, overload, or recovery, and accurately predict fatigue parameters.
Seon Du Choi +5 more
wiley +1 more source

