Results 91 to 100 of about 9,957,628 (348)
Advanced Engineering Materials, EarlyView.Additive manufacturing (AM) allows great geometric freedom for lightweight components. As parts are progressively optimized exploiting potentials in AM leading in smaller material cross sections, high pressure solution treating and aging (STA) treatments show an enormous potential for strongly improving material properties.
Mika León Altmann +4 more
wiley +1 more source
Experiment and simulation calculation of micro-cavity dielectric barrier discharge
Results in Physics, 2018 In order to study the discharge mechanism and discharge parameters evolution of micro-cavity dielectric barrier discharge (MDBD), an experimental platform based on the dielectric panel surface grid micro-structure electrode device was built.
Yanzhou Sun +3 more
doaj +1 more source
, 2019 A special surface discharge is proposed based on the multi-anode electrode geometry. Instead of the traditional surface flashover of creepage on the insulator surface between the electrodes, a surface discharge with one of the electrodes being placed far
Cui, Weisheng +2 more
core
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
An Evaluation of the Effect of Discharging a High Quality Effluent into a Small Ozark Mountain Stream [PDF]
, 1990 Recently the newly constructed Fayetteville wastewater treatment plant went on line and directed a portion of its discharge to a point in the Mud Creek drainage basin that had previously not received any effluent.
Cotter, Floyd E. +2 more
core +2 more sources
, 2015 The removal of isovaleric acid (IVA) and trimethylamine (TMA) using nonthermal plasma (NTP) in a continuous surface discharge reactor is investigated.
A. Assadi +3 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Floating structures in shallow water: local well-posedness in the axisymmetric case
, 2019 The floating structure problem describes the interaction between surface water waves and a floating body, generally a boat or a wave energy converter. As shown by Lannes in [18] the equations for the fluid motion can be reduced to a set of two evolution ...
Bocchi, Edoardo
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source