Scientific Reports, 2021 Polyethylene terephthalate (PET) fibers and fabrics are widely used for medical device applications such as vascular and anterior cruciate ligament prostheses.
Tuan Ngoc Nguyen +3 more
doaj +1 more source
Surface profile prediction and analysis applied to turning process [PDF]
, 2008 An approach for the prediction of surface profile in turning process using Radial Basis Function (RBF) neural networks is presented. The input parameters of the RBF networks are cutting speed, depth of cut and feed rate.
LU, Chen, COSTES, Jean-Philippe
core +1 more source
Surface Finish and Residual Stresses Induced by Orthogonal Dry Machining of AA7075-T651. [PDF]
Materials (Basel), 2014 Jomaa W, Songmene V, Bocher P.
europepmc +2 more sources
Pre-evaluation on surface profile in turning process based on cutting parameters [PDF]
, 2009 Traditional online or in-process surface profile (quality) evaluation (prediction) needs to integrate cutting parameters and several in-process factors (vibration, machine dynamics, tool wear, etc) for high accuracy.
MA, Ning +3 more
core +1 more source
Running-in wear modeling of honed surface for combustion engine cylinder liners [PDF]
, 2013 The texture change during running-in alters the performance and efficiency of a tribo-mechanical system. During mass production of cylinder liners, a final finishing stage known as ‘‘plateau honing’’ is commonly added to reduce the running-in wear ...
EL MANSORI, Mohamed +3 more
core +1 more source
Performance impact of honing dynamics on surface finish of precoated cylinder bores [PDF]
, 2013 The surface modification of engine cylinder bores with improved sliding properties is often produced by the honing process. This multi-stage process is performed using abrasive stones loaded against the bore with simultaneous rotation and oscillation. To
SABRI, Leila +2 more
core +1 more source
Nano-Surface Generation Using Low-Pressure Super-Finishing With Fine Diamond Stones
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2008 The fixed-abrasive process has been attracting attention as an alternative to the abrasive-free process for finishing surfaces, by virtue of its capacity to improve formability and alleviate environmental problems.
Sachiko OGAWA +3 more
doaj +1 more source
Experimental investigation on wear behavior of titanium alloy (Grade 23) by pin on disc tribometer
Results in Materials, 2023 In this paper, investigating the influence of wear properties such as load, distance, and sliding speed are analyzed to statistical behavior of the wear mass loss and co efficient of frictions as response using high-strength titanium alloys (Grade 23 ...
Sivaprakasam P, Tesfalem Hailu, Elias G
doaj +1 more source
Cavitation erosion of electrostatic spray polyester coatings with different surface finish [PDF]
Bulletin of the Polish Academy of Sciences: Technical Sciences, 2021 Polyester coatings are among the most commonly used types of powder paints and present a wide range of applications. Apart from its decorative values, polyester coating successfully prevents the substrate from environmental deterioration.
Mirosław Szala +2 more
doaj +1 more source
Influence of a pulsed laser regime on surface finish induced by thedirect metal deposition process on a Ti64 alloy [PDF]
, 2014 tThe direct metal deposition (DMD) laser technique is a free-form metal deposition process, which allowsgenerating a prototype or small series of near net-shape structures.
GORNY, Cyril +7 more
core +1 more source