Results 141 to 150 of about 198,581 (309)
Enhancing Bubble Removal in Geometry‐Optimized Electrodes
Advanced Engineering Materials, EarlyView.3D‐printed lattice electrodes outperform stochastic foams in alkaline water electrolysis despite 20%–25% lower surface area. Straight flow channels generate Venturi‐like bubble entrainment, suppressing gas accumulation that renders foam interiors electrochemically inactive.
Florian Wiesner +5 more
wiley +1 more source
Numerical Simulation of Flow Field Formed in Water Pump-Sump [PDF]
, 2008 Two fundamental types of flow problems besetting water intakes are swirling flow problems in the pump sump and sediment problems at entrance or within intakes.
BOIS, Gérard +2 more
core
From Shear to Sound: Mechanics–Acoustics Mapping of TPMS Lattices
Advanced Engineering Materials, EarlyView.Triply periodic minimal surface (TPMS) lattices are mapped across mechanical and acoustic performance, revealing that descriptors validated in compression fail under shear. First‐time comparison with trusses included. A transition from porous to resonance‐driven absorption emerges at 25% density.
Lucía Doyle +3 more
wiley +1 more source
Energy Conversion and Management: XThe present work examines that how the fins attached to the inner surface of a vertically oriented pipe affect the flow as well as thermal characteristic of the nanofluid flow when exposed to sunlight-induced heating.
Assmaa Abd-Elmonem +9 more
doaj +1 more source
Heat transfer from swirling impinging jets [PDF]
, 1980 This thesis is concerned with the determination of the local and average mass/heat transfer--from swirling jets impinging orthogonally onto flat surfaces.
Mahmood, M.
core
Influence of Geometric Design on Mechanical Performance of Auxetic Metastructure
Advanced Engineering Materials, EarlyView.Strategic geometric reinforcement transforms auxetic performance. This study evaluates 3D‐printed arrowhead metastructures, revealing that a modified design with local ring reinforcement suppresses premature failure to achieve superior energy absorption and structural efficiency.
Muhammad Gulzari +3 more
wiley +1 more source
Burning velocity of premixed turbulent flames in the weakly wrinkled regime [PDF]
, 2005 PhDTurbulent burning velocities have been measured for methane/air and ethylene/air planar flames stabilised in a wide-angled conical diffuser where the flow is decelerated axially.
Savarianandam, Vivek Ross
core
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
A Study on Water Modeling of Ladle with Bottom Argon Blowing in Critical Slag Entrapment Condition
Teshugang, 2009 According to a 70 t ladle prototype at steel works, the water model with model-prototype linear scale ratio 1：2.75 has been established. The obtained critical blowing gas rate was 450 L/min by water modeling test to measure the rate of ladle bottom ...
艾新港, 包燕平, 吴华杰, 马鑫
doaj
Advanced Engineering Materials, EarlyView.A combined experimental–computational framework identifies energy‐dependent laser absorptivity for NiTi in laser powder‐bed fusion, applicable to conduction and transition modes. Single‐track experiments and thermofluid smoothed particle hydrodynamics simulations are coupled through inverse analysis of melt pool geometry.
Mohamadreza Afrasiabi +3 more
wiley +1 more source