Results 171 to 180 of about 1,112,231 (274)

Mechanical self-adaptive porous valve relying on surface tension for energy harvesting from low-flux bubbles. [PDF]

Nat Commun
Du Y, Li P, Wen Y, Fan Y, Liu Z.
europepmc   +1 more source

Surface tension measurement and calculation of model biomolecular condensates.

Soft Matter, 2023
Holland J, Castrejón-Pita AA, Tuinier R, Aarts DGAL, Nott TJ.   +4 more
europepmc   +1 more source

On the Influence of Antioxidants and Recycled MgO–C Source Material on the Mechanical Properties of Carbon‐Bonded Magnesia Refractories

Advanced Engineering Materials, EarlyView.
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann, Tom Weber, Jana Hubálková, Florian Kerber, Dinesh Kumar Gunasekar, Hans Jelitto, Christos G. Aneziris   +6 more
wiley   +1 more source

On the evaluation of surface tension of biodiesel. [PDF]

Sci Rep
Rezaei F, Arab Juneghani MR, Keshavarz Moraveji M, Rafiei Y, Sharifi M, Ahmadi M, Hemmati-Sarapardeh A.   +6 more
europepmc   +1 more source

Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland, Finn‐Lennard Janthur, Sarah Seffer, Jörg Hermsdorf, Ludger Overmeyer, Annika Raatz   +5 more
wiley   +1 more source

Quantifying surface tension of metastable aerosols via electrodeformation. [PDF]

Nat Commun
Shahabadi V, Vennes B, Schmedding R, Zuend A, Mauzeroll J, Schougaard SB, Preston TC.   +6 more
europepmc   +1 more source

Surface Tension [PDF]

Nature, 1934
openaire   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Curvature-Enhanced Superomniphobic Property for Minimizing Contact Time of Low-Surface-Tension Liquid. [PDF]

Small Sci
Ahn H, Yun GT, Ryu J, Jang GM, Im SG, Jung HT.   +5 more
europepmc   +1 more source

Investigation of Thermo‐Chemical Processes in Commercial MgO‐C Refractory Bricks With and Without MgO‐C Recyclate at Elevated Temperatures

Advanced Engineering Materials, EarlyView.
This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm, Jana Hubálková, Christian Schimpf, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +6 more
wiley   +1 more source