Results 231 to 240 of about 1,119,298 (307)

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Effects of surface tension and contact angle on pore structure development of coal samples under chemical solution erosion. [PDF]

Sci Rep
Chen H, Wang L, An W.
europepmc   +1 more source

Density and Surface Tension of CuxO Bearing Slags

, 2003
T. Takasu, Hideyuki Itou, Takashi Nakamura   +2 more
openalex   +1 more source

Engineering Deformation and Failure in Diamond Triply Periodic Minimal Surface Lattices via 3D Wall‐Thickness Grading

Advanced Engineering Materials, EarlyView.
The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza, Danilo Bruson, Manuela Galati, Luca Iuliano   +3 more
wiley   +1 more source

Experimental Research on Surface Tension of R125

Zhileng xuebao, 2000
雷霞, 段远源, 史琳, 朱明善, 韩礼钟   +4 more
doaj   +2 more sources

Impact of Simulated Gastrointestinal Fluid: Viscosity, Surface Tension, and pH on the Dissolution and Rheology Assessment of Viscosity of Two Commercial Candesartan Cilexetil Products. [PDF]

Turk J Pharm Sci
Ata S, Sejare R, Tarawneh O, Hamed R, Al-Sabi M, Bishtawi S, Mahfouz HA, Alkouz S.   +7 more
europepmc   +1 more source

The dependence of surface tension on surface properties of ionic surfactant solution and the effects of counter-ions therein

, 2014
Chuangye Wang, Harald Morgner
openalex   +2 more sources

Removing Homocoupling Defects in Alkoxy/Alkyl‐PBTTT Enhances Polymer:Fullerene Co‐Crystal Formation and Stability

Advanced Functional Materials, EarlyView.
PBTTT‐OR‐R, a C14‐alkoxy/alkyl‐PBTTT polymer derivative, is of substantial interest for optoelectronics due to its specific fullerene intercalation behavior and enhanced charge‐transfer absorption. Comparing this polymer with (S) and without (O) homocoupling defects reveals that PBTTT‐OR‐R(O) forms stable co‐crystals with PC61BM, while PBTTT‐OR‐R(S ...
Zhen Liu, Jochen Vanderspikken, Paola Mantegazza, Stefania Moro, Mouna Hamid, Sigurd Mertens, Niko Van den Brande, Laurence Lutsen, Vincent Lemaur, David Beljonne, Giovanni Costantini, Koen Vandewal, Bruno Van Mele, Wouter Maes, Bart Goderis   +14 more
wiley   +1 more source

Process Optimization in a Condiment SME through Improved Lean Six Sigma with a Surface Tension Neural Network [PDF]

Manuel Vargas, Rodolfo Mosquera, Guillermo Fuertes, Miguel Alfaro, Ileana Pérez-Vergara   +4 more
openalex   +1 more source

Photoswitchable Conductive Metal–Organic Frameworks

Advanced Functional Materials, EarlyView.
A conductive material where the conductivity can be modulated remotely by irradiation with light is presented. It is based on films of conductive metal–organic framework type Cu3(HHTP)2 with embedded photochromic molecules such as azobenzene, diarylethene, spiropyran, and hexaarylbiimidazole in the pores.
Yidong Liu, Mersad Mostaghimi, Abhinav Chandresh, Saibal Jana, Wolfgang Wenzel, Lars Heinke   +5 more
wiley   +1 more source