Results 81 to 90 of about 5,391 (262)

Strong Lead‐Free Bioinspired Piezoceramics for Durable Energy Transducers

open access: yesAdvanced Functional Materials, EarlyView.
We fabricated brick‐and‐mortar lead‐free piezoceramics with Bi0.5Na0.5TiO3 monocrystal platelets as bricks and amorphous silica as mortar. The alignment of the bricks and the presence of the amorphous silica led to anisotropic residual stresses. These residual stresses increase the samples toughness, strength and durability while the brick alignment ...
Ruxue Yang   +12 more
wiley   +1 more source

Suspended sediment load prediction using long short-term memory neural network. [PDF]

open access: yesSci Rep, 2021
AlDahoul N   +6 more
europepmc   +1 more source

Tannic Acid‐Modified Cellulose Nanofiber Reinforced Polymerizable Eutectogels for High‐Performance Stretchable Strain Sensors

open access: yesAdvanced Functional Materials, EarlyView.
A polymerizable deep eutectic solvent is reinforced with tannic acid‐modified cellulose nanofibers to construct a hierarchical dynamic eutectogel network. Synergistic covalent and reversible interactions impart ultrahigh stretchability, high ionic conductivity, broad temperature tolerance, self‐healing, and strong adhesion, enabling robust wearable ...
Huang Wu   +11 more
wiley   +1 more source

Catalytically Enhanced Near Room‐Temperature Hydrogen Sensing Using Pd‐ZnO Colloidal Crystals

open access: yesAdvanced Functional Materials, EarlyView.
Pd‐decorated ZnO colloidal crystal monolayers demonstrate excellent performance across a wide hydrogen concentration range at 33°C, with high selectivity and reproducible device fabrication. The sensors show strong responses even at low‐ppm H2 concentrations and an ultra‐low detection limit of 82 ppb, indicating their suitability for diverse hydrogen ...
Hamidah Alluhaybi   +13 more
wiley   +1 more source

Analysis of concentration and sedimentation of suspended load in the reservoirs

open access: yes, 2008
however, chlorite was also found, as well as small quantities of plagioclase and organic detritus. With regard to the size of the particles the examined samples are classified as silt. It was determined that the concentration of the suspended load, at the same flow rate of water, at the intake into the reservoir is larger than at the outflow.
Vrecl-Kojc, Helena   +3 more
openaire   +3 more sources

Functionalizing Micro‐to‐Mesoscopic Electrode Architectures for Regulating Electron Transfer Behaviors in Electrocatalysis

open access: yesAdvanced Functional Materials, EarlyView.
A systematic review is conducted to assess the influence of electrode architecture across micro‐ to mesoscopic length scales on electron‐transfer pathways in electrocatalysis. We discuss the structure‐activity relationships in electrocatalytic applications, including resource recovery and environmental remediation, and provide cost‐effective, efficient
Manshu Zhao   +6 more
wiley   +1 more source

Nanodiamond Sensing in Dynamic Environments With Fast‐Tracking Through Four‐Point Positioning

open access: yesAdvanced Functional Materials, EarlyView.
A four‐point positioning tracking (4PPT) platform enables fast 3D feedback translational tracking of fluorescent nanodiamonds while simultaneously recording ODMR spectra. By integrating real‐time translational tracking with quantum sensing, mobile nanodiamonds are used for in‐situ nanothermometry, nanorheometry, and 6D translation–rotation tracking in ...
Guoli Zhu   +10 more
wiley   +1 more source

Mechanisms of Degradation in Li‐Ion Batteries Under Low Temperature Exposures

open access: yesAdvanced Functional Materials, EarlyView.
Low‐temperature exposures, or freeze‐thaw cycles, are observed to significantly accelerate the degradation of Li‐ion batteries. A combination of electrolyte phase separation and mechanochemical stress leads to reversible and irreversible performance losses.
Mihir Ojha   +12 more
wiley   +1 more source

One‐Step Curcumin‐Mediated Multiphoton Lithography for Bioactive 3D Scaffolds

open access: yesAdvanced Functional Materials, EarlyView.
Curcumin‐mediated multiphoton lithography enables one‐step fabrication of highly architected complex gelatin methacryloyl scaffolds by exploiting curcumin as a multifunctional bioactive photoinitiator. The resulting 3D structures support mesenchymal stem cell adhesion, proliferation, and migration, while exhibiting dual antibacterial activity through ...
Myrto Charitaki   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy