Results 101 to 110 of about 91,551 (149)

‘Oxygen Bound to Magnesium’ as High Voltage Redox Center Causes Sloping of the Potential Profile in Mg‐Doped Layered Oxides for Na‐Ion Batteries

Advanced Functional Materials, EarlyView.
Na‐ion batteries ‐ Impact of doping on the oxygen redox: The sloping potential of NaMg0.1Ni0.4Mn0.5O2 above 4.0 V is caused by a new redox center (arising from the ‘O bound to Mg’), having a higher potential but being more irreversible compared to the ‘O bound to Ni’.
Yongchun Li, Konstantin Köster, Katherine A. Mazzio, Yanan Sun, Annica I. Freytag, Deniz Wong, Christian Schulz, Götz Schuck, Volodymyr Baran, Alba San Jose Mendez, Marcin Zając, Payam Kaghazchi, Philipp Adelhelm   +12 more
wiley   +1 more source

Anomalous Stiffening of a Conjugated Polymer During Electrochemical Oxidation

Advanced Functional Materials, EarlyView.
The electromechanical response of a thienothiophene‐based conjugated polymer with triethylene glycol side chains is investigated. Electrochemical nanoindentation and atomic force microscopy reveal a modest and reversible increase in elastic modulus at room temperature upon electrochemical oxidation.
Judith Pons i Tarrés, Di Zhu, Chiara Musumeci, Youngseok Kim, Dilara Meli, Hang Yu, Meghna Jha, Bryan D. Paulsen, Ruiheng Wu, Joost Kimpel, Zachary Laswick, Sri Harish Kumar Paleti, Yadong Zhang, Stephen Barlow, Seth R. Marder, Jenny Nelson, Jonathan Rivnay, Christian Müller   +17 more
wiley   +1 more source

Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting

Advanced Functional Materials, EarlyView.
A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar, Francisca P. Correia, Inês M. Freitas, Vítor M. Gaspar, João F. Mano   +4 more
wiley   +1 more source

Copper Single‐Atom Decorated Microfibrous Catalysts for Continuous‐Flow Reduction of Nitroarenes

Advanced Functional Materials, EarlyView.
Herein, a Cu‐single‐atom decorated, microfibrous catalyst (Cu1/CMF) is fabricated for chemoselective reduction of nitroarenes, demonstrating a superior processing capacity of 1.92 mmol mgcat−1 h−1 and superior durability (≥ 25 cycles) in a continuous‐flow manner.
Jiahan Zhao, Yingshuang Li, Zhuoyuan Bi, Guanwu Lian, Guokang Chen, Pei Liu, Yuan Meng, Fangrun Jin, Xiaoxu Zhao, Zhonghua Li, Jianyong Feng, Jiangbo Xi, Zhongxin Chen   +12 more
wiley   +1 more source

Upcycling of Disposable Face Masks into Water‐Resistant and Flame Retardant Foams

Advanced Functional Materials, EarlyView.
Disposable mask waste is upcycled into lightweight polypropylene‐based foams with tunable porosity and composite architectures reinforced by ear‐loop fibers. The sustainable solvent‐based process enables upcycling rates of 91% and solvent recovery of >90%.
Jingjing Pan, Erlantz Lizundia, Hao Jia, Lennart Bergström   +3 more
wiley   +1 more source

Switchable Thermal Mid‐IR Conducting Polymer Antenna Arrays

Advanced Functional Materials, EarlyView.
This study presents switchable mid‐infrared plasmonic resonances in PEDOT antenna arrays. Their optical extinction peaks can be reversibly switched ‘OFF’ and ‘ON’ by tuning the polaronic charge carrier concentration via the polymer's redox state, offering modulation of optical responses in the thermal mid‐infrared range including around 10 µm ...
Pravallika Bandaru, Mohammad Shaad Ansari, Suraya Kazi, Dongqing Lin, Alexander Yu Polyakov, Magnus P. Jonsson   +5 more
wiley   +1 more source

Micro and Nanostructural Diversity of Lizard Osteoderm Capping Tissue in Relation to Mechanical Performance

Advanced Functional Materials, EarlyView.
This study shows that lizard osteoderm capping tissue is a hyper‐mineralized hydroxyapatite layer consistently covering the superficial osteoderm surface in those species studied here, yet it varies greatly in morphology, nanostructure, and mechanical performance across species.
Adrian Rodriguez‐Palomo, Marius Didziokas, Malene Siri Berg Jacobsen, Thorbjørn Erik Køppen Christensen, Innokenty Kantor, Mads Ry Vogel Jørgensen, Klaus Pagh Almtoft, Jesper Skovhus Thomsen, Anthony Herrel, Catherine J.A. Williams, Henrik Birkedal   +10 more
wiley   +1 more source

Manufacturing Productivity in Sweden: an International Perspective Since 1960 [PDF]

International Productivity Monitor, 2005
Daniel Lind
doaj  

Dual‐Layer Living Hydrogel Enables On‐Demand Delivery of Phages and Probiotics for Synergistic Wound Infection Therapy

Advanced Functional Materials, EarlyView.
A dual‐layer living hydrogel, ProΦGel, integrates bacteriophages and probiotics for synergistic wound infection therapy. The outer gelatin‐based matrix releases phages on demand in response to P. aeruginosa infections, while inner alginate beads sustain probiotic delivery.
Siyuan Tao, Darine D'Adam, Anna Hu, Sixuan Zhang, Josua Roduner, Katharina Maniura‐Weber, Qun Ren   +6 more
wiley   +1 more source

Xeno‐Free Biocompatible Peptide‐Based Bioinks Reinforced with Cellulose Nanofibers for 3D Printing

Advanced Healthcare Materials, EarlyView.
A xeno‐free bioink combining self‐assembled peptides and cellulose nanofibers is developed for 3D printing. The bioink forms a non‐cross‐linked 3D scaffold, mimicking the extracellular matrix and supporting over 95% cell viability. This approach offers enhanced biocompatibility and mechanical stability, advancing 3D printing for personalized medicine ...
Francesca Netti, Mor Tsuriano, Noam Rattner, Vania Altobelli, Yoav Dan, Lihi Adler‐Abramovich   +5 more
wiley   +1 more source