Results 21 to 30 of about 7,265 (265)
A Wide-Band High-Resolution Transmitter for Optical Isolation Amplifier
A wide-band and high-resolution transmitter of optical isolation amplifier is proposed for switching power supply isolation and servo motor drive applications. The transmitter is based on the chopper-stabilized technique and sigma delta modulator.
Chengying Chen +3 more
doaj +1 more source
A Gliding Arc Microreactor Power Supply System Based on Push–Pull Converter Topology
The era of evolution in power electronic systems has led to a widespread displacement of power supplies operating at mains frequencies. Switched-mode power inverters offer possibilities incomparably higher than mains transformers.
Piotr Krupski +1 more
doaj +1 more source
Redundant Switched-mode Power supplies (SMPSs) are commonly used to improve electronic systems’ reliability, and accurate estimation of the current sharing state is significant for evaluating the system’s health.
Peng He +4 more
doaj +1 more source
Step-up/step-down regulators in maximum power transmission mode
Introduction. Switching DC voltage regulators are traditionally used to regulate and stabilize the voltage on the load. Due to the widespread use of non-traditional and renewable sources of electricity, there is a need to select from them the maximum ...
V. Y. Romashko +2 more
doaj +1 more source
For the distribution area with a high penetration rate of new energy, the traditional power supply system has some problems, such as a single form of power supply and low utilization of new energy.
Shumei Chi +3 more
doaj +1 more source
Asynchronous Digital Low-Dropout Regulator With Dual Adjustment Mode in Ultra-Low Voltage Input
This paper presents the asynchronous digital low-dropout regulator (AD-LDO) with dual adjustment mode in ultra-low voltage input. The architecture of the proposed AD-LDO consists of the asynchronous control loop and the power PMOS array.
Wei-Bin Yang +3 more
doaj +1 more source
A novel energy harvesting technique that uses conducted electromagnetic interference as an energy source is presented. Conducted EMI generated from fluorescent light using a switched-mode power supply was measured and modeled as an equivalent voltage ...
Chang-Hee Hyoung, Jung-Hwan Hwang
doaj +1 more source
Nitriding of Long-Term Holes in the Cyclic-Commuted Discharge
The effect of anhydrous nitriding in a glow discharge on microhardness, phase composition, and wear resistance of long holes in steels C45, 37Cr4, and 41CrAlMo7 with direct current supply and in cyclically switched discharge (CSD) was studied.
Stechyshyn M. +2 more
doaj +1 more source
An inspection circuit for AC and DC power supply and its control method
In view of the problem that the train need be switched in AC and DC power supply system, an inspection circuit and control method were designed to inspect the AC and DC power supply system.
HUANG Hao +3 more
doaj
Simulation of Active Magnetic Bearing Response based NNC [PDF]
The present work is dealing with the modeling, investigations, and controlling, of a prototype radial magnetic bearing system. Considerations based on the 8 poles model with switched mode power supply.
Naseer Qassim Hamoody, Adil Hameed Ahmad
doaj +1 more source

