Results 11 to 20 of about 266,635 (246)
Converter with Synchronous Rectifiers for Electroplating [PDF]
This paper presents the requirements for resources for electroplating processes, principles of the synchronous rectifier and its control. It describes simulation and experimental verification of the synchronous rectifier, compares the efficiency of ...
Peter Hurtuk +2 more
doaj +3 more sources
2.4 GHz GaN HEMT Class-F Synchronous Rectifier Using an Independent Second Harmonic Tuning Circuit
This paper proposes a class-F synchronous rectifier using an independent second harmonic tuning circuit for the power receiver of 2.4 GHz wireless power transmission systems.
Kang-Yoon Lee +2 more
exaly +4 more sources
Flyback Converter Using a D-Mode GaN HEMT Synchronous Rectifier
The flyback converter with its active cell balancing topology for charging lithium-based batteries in Electrical Vehicles (EV) have been adopted recently into the industry. Electrical Vehicle battery charging requires high current operation in continuous
Yueh-Tsung Shieh +4 more
doaj +2 more sources
Diode rectifier configurations with a multiphase synchronous generator [PDF]
Direct current (DC) power networks are widely used in transport applications, often derived from a synchronous generator and diode rectifier. The use of more than three phases to reduce the DC voltage ripple eliminates the DC filter capacitance and ...
Xiaotao Zhang, Judith Apsley
doaj +4 more sources
Design of bootstrap integrated synchronous rectifier
Based on the research of the development of synchronous rectification technology, this paper proposes a circuit structure of bootstrap synchronous rectifier chip.
LIU Shulin +4 more
doaj +3 more sources
This paper presents the fault tolerance of model predictive direct torque control for a permanent magnet synchronous generator under a faulty Vienna rectifier. The fault applied includes open-switch and short-switch fault in a particular active switching
Sook Yee Yip +4 more
doaj +2 more sources
Research on the Push-pull Forward Capacitor Clamp Zero-voltage Synchronous Rectifier Converter
In order to improve the efficiency of the push-pull converter, a clamp capacitor is connected in series between the center tap of the high voltage side of the primary side of the traditional push-pull circuit, so that the leakage energy can be absorbed ...
LIU Guowang, ZHANG Yuchi, WANG Lin
doaj +3 more sources
Analysis of Piezoelectric Energy Harvesting Interface Circuit Applied to Automobile Engine Vibration [PDF]
In order to realize the continuous power supply for the vibration fault monitoring system of automobile engine, aiming at the low efficiency and instability of the existing piezoelectric full bridge rectifier energy collection circuit, this paper ...
Zhaona LU, Wang Junlong
doaj +1 more source
Reduction of the Induced Voltage in the Synchronous Generator Shaft Using Active AC / DC Converter
Today, synchronous generators are broadly employed in the industry. The thyristor rectifier in the static excitation system of synchronous generators is responsible for supplying the DC voltage of the excitation winding.
Mohamad Rostami Engasi +2 more
doaj +1 more source
Aiming at the transient overvoltage problem of high proportion new energy multi direct current (DC) transmission system caused by DC blocking fault, the interaction mechanism between multiple DC lines is analyzed firstly and the multi-outfeed voltage ...
ZHANG Qirui +5 more
doaj +1 more source

