Results 161 to 170 of about 390,759 (303)

Quantifying glare phenomena in patients with different intraocular lenses using a standard and modified clinical straylight meter. [PDF]

J Cataract Refract Surg
Naujokaitis T, Rayamajhi A, Auffarth GU, van den Berg TJTP, Khoramnia R, Łabuz G.   +5 more
europepmc   +1 more source

SYNERGY AND ISOBOLES

British Journal of Anaesthesia, 1993
openaire   +2 more sources

A Dislocation Perspective on Strength and Toughness in Ceramics

Advanced Engineering Materials, EarlyView.
Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley   +1 more source

Cooperative membrane association as a mechanistic origin of synergistic antimicrobial peptide activity. [PDF]

RSC Chem Biol
Medvedeva A, Kolomeisky AB.
europepmc   +1 more source

Compatibility of Methacrylate Based Resins Controls Interfacial Failure and Toughness in 3D‐Printed Multimaterial Composites

Advanced Engineering Materials, EarlyView.
This work shows that the mechanical performance of multimaterial digital light processing (DLP) printed thermoset composites is governed by resin compatibility and interfacial design rather than spatial patterning alone. Brittle and ductile resin combinations produced premature interfacial failure, while graded interfaces and mechanically compatible ...
Ahmed M. H. Ibrahim, Li Meng, Ahmad R. Najafi, Nicolas J. Alvarez   +3 more
wiley   +1 more source

Two strategies of anticipatory mechanism during change in frequency of cyclic multi-finger force production in isometric conditions. [PDF]

Exp Brain Res
Park J, Kim HS, Choi YS, Lee S, Shin N, Park J.   +5 more
europepmc   +1 more source

Influence of Si Content and Milling Duration on the Microstructure and Mechanical–Tribological Properties of AlCoCrFeNiSi High‐Entropy Alloys

Advanced Engineering Materials, EarlyView.
Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş, Mehmet Emin Demir, Sercan Özpınar   +2 more
wiley   +1 more source

Influence of surgical intervention on pre- and post-surgery patient specific muscle synergies in children with cerebral palsy. [PDF]

Exp Brain Res
Breust T, Lin J, Cheung VCK, Salami F, Wolf SI, Alici G, Sreenivasa M.   +6 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Relationship between lower limb muscle coordination and knee flexion angle during the swing phase of gait in post-stroke individuals. [PDF]

J Neuroeng Rehabil
Karino T, Aoyama T, Yoshikawa K, Ishibashi K, Kohno Y.   +4 more
europepmc   +1 more source