Barekeng, 2022 In the current study, combining the powder with dielectric fluid in electrical discharge machining (PMEDM) is a very fascinating technological approach.
Veniola Forestryani +2 more
doaj +1 more source
Neural network prediction of relativistic electrons at geosynchronous orbit during the storm recovery phase: effects of recurring substorms [PDF]
Annales Geophysicae, 2002 During the recovery phase of geomagnetic storms, the flux of relativistic (>2 MeV) electrons at geosynchronous orbits is enhanced. This enhancement reaches a level that can cause devastating damage to instruments on satellites. To predict these
M. Fukata +4 more
doaj +1 more source
Application of Taguchi Approache to Study the Effect of Filler Type on Tribological Behavior of Polymer Composite Under Dry Conditions [PDF]
Engineering and Technology Journal, 2014 The tribological behaviour of a G-P ( glass-polyester ) composite system and G-P composite systems interfaced with graded fillers were tested. The composite materials of G-P and G-P reinforced with SiC and Graphite particles as secondary fillers were ...
Drai Ahmed Smait +2 more
doaj +1 more source
Using Taguchi Design to Compare the Corrosion Behavior of Commercial Pure Ti Alloys Coated by Dip and Electrophoretic Deposition with YSZ [PDF]
Engineering and Technology Journal, 2023 This study makes experimental evaluations of the corrosion and tip tests of CP-Ti joint (commercial pure Ti) implant alloys coated with YSZ nanoceramic. A Taguchi design of experiments (DOE) strategy was used to create a thin adhesive covering utilizing
Marwan Hussein +2 more
doaj +1 more source
Optimize the Taguchi method, the signal-to-noise ratio, and the sensitivity
International Journal of Statistics and Applied Mathematics, 2023 Statistical quality control methods are a collection of strategies and scientific techniques to study many different complex production problems, which is an essential aspect of ensuring.
D. K. Rashid
semanticscholar +1 more source
A combination method for multi-criteria decision making problem in turning process
Manufacturing Review, 2021 This paper presents a multi-criteria decision making (MCDM) for a turning process. An experimental process was performed according to the sequence of a matrix using the Taguchi method with nine experiments.
Duc Trung Do
doaj +1 more source
OPTIMIZATION OF DRY TURNING PROCESS PARAMETERS USING TAGUCHI METHOD COMBINED WITH FUZZY LOGIC APPROACH [PDF]
Proceedings on Engineering Sciences, 2019 In this paper, Taguchi method combined with fuzzy logic approach was used in order to define dry turning process parameters values that lead to minimal surface roughness.
Mario DRAGIČEVIĆ +2 more
doaj +1 more source
Machines, 2022 In the present study, a comparison of two widely used optimization approaches for fused deposition modeling (FDM), that is, Taguchi method in contrast with response surface method (RSM), was investigated.
Ge Gao, Fan Xu, Jiangmin Xu
semanticscholar +1 more source
Effect of High Speed Machining on Surface Roughness Characteristics Ra, Rq, RZ [PDF]
E3S Web of Conferences, 2023 Today’s machining industries experience a variety of challenges, but achieving high quality in terms of dimensional accuracy, surface quality, and production rate is their key concern.
Khare Sanchit Kumar +3 more
doaj +1 more source
Scientific Reports, 2021 In the present study, the simultaneous removal of malachite green (MG) and auramine-O (AO) dyes from the aqueous solution by NaX nanozeolites in a batch system is investigated.
S. Shojaei +5 more
semanticscholar +1 more source