Results 141 to 150 of about 7,236 (298)
Phase‐Pure and Size‐Tunable Tin Halide Perovskite Quantum Dots
Advanced Materials, EarlyView.A trioctylphosphine oxide modulated protocol allows for the synthesis and study of the optical properties of a broad library of tin halide perovskite quantum dots across multiple A‐ and X‐site compositions with precise size tuning while eliminating unwanted 2D phases.
Ole F. Dressler +7 more
wiley +1 more source
Advances in Magnesium‐Based Thermoelectrics: A Critical Review
Advanced Materials, EarlyView.Magnesium‐based thermoelectric materials have emerged as promising candidates for low‐to‐mid‐temperature energy conversion due to their abundance, low cost, and competitive performance. This review summarizes recent advances in Mg3X2, MgAgSb, and Mg2X systems, covering transport mechanisms, fabrication strategies, stability challenges, and device ...
Li‐Min Zhang +5 more
wiley +1 more source
Design and optimization of a microfiber coupler for biosensing [PDF]
We design and optimize a simple, low-cost and compact biosensor based upon a microfiber coupler, with a predicted sensitivity and detection limit up to S~104 nm/RIU and DL~10-6 RIU ...
Brambilla, Gilberto +5 more
core +1 more source
Weaving Intelligence: Thermally Drawn Multimaterial Fibers Toward AI‐Enabled Smart Textiles
Advanced Materials, EarlyView.Thermally drawn multimaterial fibers are rapidly advancing as intelligent structural units for next‐generation smart textiles. Integrating multimaterial architectures with neuromorphic and spiking‐neural‐network principles enables fabrics that can sense, compute, and adapt autonomously.
Vuong Dinh Trung +9 more
wiley +1 more source
Near‐Unity Chiral Lasing Enabled by Quasi‐Bound States in the Continuum
Advanced Materials, EarlyView.Nanoimprinted chiral array that supports bound states in the continuum is doped with an efficient non‐chiral molecule (Rhodamine‐B) acting as gain medium to produce fully circularly polarized lasing emission. The chiral lasing wavelength can be tuned across the emission band of Rhodamine‐B by adjusting the coating thickness of the TiO2 high refractive ...
Jose Mendoza‐Carreño +5 more
wiley +1 more source
pH sensor made using cellulosic coating on a biconically tapered singlemode optical fiber [PDF]
, 2000 A pH sensor has been fabricated using a tapered single-mode optical fiber coated with cellulose and direct dyes.
Ilundain, Inaki +3 more
core
Thermo-Optical Switching Effect Based on a Tapered Optical Fiber and Higher Alkanes Doped with ZnS:Mn. [PDF]
Materials (Basel), 2020 Moś JE +3 more
europepmc +1 more source
Advanced Materials, EarlyView.Inspired by the octopus and the golden wheel spider, soft robots with liquid crystal elastomer arc fibers as appendages are fabricated to transcend surface constraints through an elevated center of mass and minimal contact footprints. By leveraging curvature‐encoded deformation‐recovery cycles, these robots exhibit contractile, torsional, and flexural ...
Jong Bin Kim +5 more
wiley +1 more source
Repetitive Detection of Aromatic Hydrocarbon Contaminants with Bioluminescent Bioreporters Attached on Tapered Optical Fiber Elements. [PDF]
Sensors (Basel), 2020 Zajíc J +4 more
europepmc +1 more source
Advanced Materials Interfaces, EarlyView.3D conductive frameworks can maintain continuous electron transport, mechanical stability, and interfacial integrity, helping next‐generation batteries operate more efficiently. This Review examines their relevance to Si anodes, all‐solid‐state batteries, and dry‐processed electrodes, and highlights bio‐derived carbons as sustainable, structurally ...
SeoYoung Ha +5 more
wiley +1 more source