Results 1 to 10 of about 189,974 (125)
Buildings, 2022 This article studies the quantitative relationship between the target reliability index and the design service life for concrete main girders of cable-stayed bridges. A resistance degradation model of the concrete components is established by quantifying
Zhenhao Zhang +5 more
doaj +2 more sources
Inferring target reliability index of reinforced concrete beams in a standard fire situation according to Brazilian standards [PDF]
Revista IBRACON de Estruturas e MateriaisSince there is no consensus in the literature on the target reliability index values of reinforced concrete structures in a fire situation, this article aims to present a methodology for inferring the implicit target reliability index range for ...
Rodrigo Maffessoni Pires +1 more
doaj +2 more sources
Collapse probability and resistance factor calibration of 2D steel frames under gravity loads [PDF]
REM: International Engineering Journal, 2023 The current advanced analysis techniques for steel frames generally use structural analyses with geometric and material nonlinearities to capture the collapse strength of the steel frame.
Danilo Luiz Santana Mapa +2 more
doaj +1 more source
Reliability assessment of wind load combinations based on Iranian National Building Code [PDF]
مهندسی عمران شریف, 2021 The new generation of design codes is established by reliability-based calibration methods. The overall aims of these methods are to achieve consistent levels of safety or structural reliability under different type of uncertainties.
A. Kakaie +4 more
doaj +1 more source
Load Resistance Factor for Vertical Caisson Breakwater in Korea
Journal of Marine Science and Engineering, 2022 The load resistance factor according to the target reliability level was proposed using 16 vertical breakwaters constructed along the coast of Korea. Limit state functions for sliding and overturning limit states were defined.
Il-Geun Lee, Dong-Hyawn Kim
doaj +1 more source
Reliability analysis and formula adjustment for shear capacity of concrete shear walls
Case Studies in Construction Materials, 2021 The Unified Standard for Reliability Design of Building Structures of China (GB50068-2001) requires that the average value of a component’s reliability index should not be lower than the target reliability index.
Xiaolong Tong, Fumin Chen, Deguo Zeng
doaj +1 more source
Determination of structural reliability of a reinforced concrete slab under fire Load [PDF]
E3S Web of Conferences, 2022 Four reinforced concrete rooms are used in this study, with varying floor areas, openings, and fuel loads. These rooms are office, Classroom, computer, and chemical laboratories of institutional buildings.
Zafarullah Nizamani +3 more
doaj +1 more source
Applied Sciences, 2021 The seismic performance of the aged-concrete gravity dam (aged-CGD) by safety assessment based on the reliability-index is the main focal point of this study.
Tahmina Tasnim Nahar +2 more
doaj +1 more source
Reliability of codes provisions for punching shear design
Revista IBRACON de Estruturas e Materiais, 2023 This paper presents a reliability analysis of the punching shear of flat slabs without shear reinforcement. The evaluation is performed for the codes ACI 318, Eurocode 2, Model Code 2010, and ABNT NBR 6118:2014.
Gustavo Ribeiro da Silva +2 more
doaj +1 more source
Target Reliability Index of Single Gravel Compaction Piles for Limit State Design [PDF]
Journal of the Korean geoenvironmental society, 2014 Target reliability index in the limit state design indicated the safety margin and it is important to determine the partial factor. To determine the target reliability index which is needed in the limit state design, the six design and construction case histories of gravel compaction piles (GCP) were investigated. The limit state functions were defined
Youngkwon You, Heuidae Lim, Joonmo Park
openaire +1 more source