Results 71 to 80 of about 99,446 (314)

Optimization of cut‐hole layout under high in situ stress based on numerical simulation and field tests

Deep Underground Science and Engineering, EarlyView.
This study investigates the blast‐induced rock damage patterns under different cut‐hole layouts and ground stress conditions through numerical simulations and field tests. The findings in this study provide valuable insights for similar underground engineering applications.
Junjie Zhao, Diyuan Li, P. G. Ranjith, Xinxin Lü, Yanliang Li, Xiaoli Su   +5 more
wiley   +1 more source

Rockburst prediction based on data preprocessing and hyperband‐RNN‐DNN

Deep Underground Science and Engineering, EarlyView.
A data preprocessing workflow is proposed to address challenges in rockburst data analysis. Coupled algorithms preprocess the data set, and hyperband optimization is used to enhance RNN performance. Results show that preprocessing improves accuracy, while dense layers enhance model stability and prediction performance.
Yong Fan, Chenxi Yin, Guangdong Yang, Shengyong Ding, Bin Tian   +4 more
wiley   +1 more source

Correlating magnetic fabrics with finite strain : comparing results from mudrocks in the Variscan and Appalachian Orogens [PDF]

, 2004
New magnetic anisotropy data from Variscan mudstones collected in the Cantabrian Arc, N Spain constrain the corresponding strain (shortening). The results are based on our previous study of mudrocks from the Valley and Ridge Province (Appalachians) where
Parés, J. M., Van Der Pluijm, B. A.
core   +3 more sources

Creep properties and constitutive model of diabase in deep water conveyance tunnels

Deep Underground Science and Engineering, EarlyView.
The axial and lateral creep characteristics of diabase were analyzed based on compression creep tests. The nonlinear viscoelastic‐plastic model capable of describing the whole creep process was established based on the fractional derivative and damage theories.
Zhigang Tao, Pengxiao Guan, Xiaojie Yang, Keyuan Liu, Mingjiu Cai, Hong Yang   +5 more
wiley   +1 more source

Fate of the Late Triassic Songpan-Ganzi Basin in the eastern Paleo-Tethys Ocean: Geochemical and geochronological constraints in the NE Tibetan Plateau

Journal of Asian Earth Sciences: X
The Songpan-Ganzi Basin in the northeastern Tibetan Plateau preserves well-developed Late Triassic flysch sequences, making it an ideal region for investigating the provenance and tectonic evolution of the basin.
Hong-Xu Mu, Dan-Ping Yan, Liang Qiu, Ruo-Yan Kong, Ling-Xiao Gong   +4 more
doaj   +1 more source

Failure characteristics and the energy criterion of rock with a through‐going joint under true‐triaxial unloading conditions: Insights from the DEM model

Deep Underground Science and Engineering, EarlyView.
The rock failure mode is significantly influenced by the contributing factors, such as the joint inclination, the initial confining pressure, and the unloading point. We found six typical rock failure modes after a large number of numerical tests. Abstract Excavation unloading damages rock masses, with preferential failure along geological defects in ...
Fei Liu, Changhui Liang, Sijia Liu, Yongjun Zhang, Luo Wang   +4 more
wiley   +1 more source

Archaean megacrystic plagioclase units and the tectonic setting of greenstones [PDF]

Large (up to 20 cm), equidimensional, commonly euhedral, plagioclase megacrysts of highly calcic composition (An sub 80-90) occur commonly in all Archean cratons in one or more of three distinct associations: (1) as cumulate crystal segregations of ...
Maczuga, D., Morrison, D. A., Phinney, W. C.   +2 more
core   +1 more source

Two-sided asymmetric subduction; implications for tectonomagmatic and metallogenic evolution of the Lut Block, Eastern Iran [PDF]

, 2011
West directed subduction zones show common characteristics, such as low structural elevation, deep trench, steep slab and a conjugate back-arc basin that are opposite to those of the east directed subduction zones.
Arjmandzadeh, R., Homam, S. M., Karimpour, M. H., Mazaheri, S. A., Medina, J. M., Santos, J. F.   +5 more
core   +2 more sources

Tertiary-Quaternary subduction processes and related magmatism in the Alpine-Mediterranean region [PDF]

, 2006
During Tertiary to Quaternary times, convergence between Eurasia and Africa resulted in a variety of collisional orogens and different styles of subduction in the Alpine-Mediterranean region.
Downes, Hilary, Harangi, Szabolcs, Seghedi, I.   +2 more
core   +1 more source

Geological and geotechnical challenges on the Great Dyke of Zimbabwe and their impact on hardrock pillar design

Deep Underground Science and Engineering, EarlyView.
The Great Dyke of Zimbabwe is notable for its rich platinum group metal deposits but poses significant geological and geotechnical challenges due to its complex rock types and structural features. Traditional pillar design methods are insufficient for addressing these complexities; the study suggests incorporating advanced techniques such as machine ...
Tawanda Zvarivadza, Hendrik Grobler, Moshood Onifade, Manoj Khandelwal   +3 more
wiley   +1 more source