Results 221 to 230 of about 2,279,786 (296)
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Modeling of PEEK Crystallization Kinetics Under Transient Thermal Conditions. [PDF]
Hamid S +5 more
europepmc +1 more source
The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Intriguing three-component four-layer stacking nanostructures formed by the self-assembly of main-chain liquid-crystalline polyurethane elastomers, as analyzed by two-dimensional small-angle X-ray scattering. [PDF]
Hasegawa Y +5 more
europepmc +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Rapid Detection of Plasticizer Migration From UV-Aged PVC Films by DART-HRMS. [PDF]
Leite-Barbosa O +4 more
europepmc +1 more source
This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source
Comparative analysis of fractional thermoelastic vibrations of a nonlocal nanobeam exposed to travelling and static thermal loads. [PDF]
Tiwari R, Gupta GK, Shivay ON.
europepmc +1 more source
Near-Wellbore Fracture Diagnosis via Strain Decoupling from Integrated In-Well LF-DAS and DTS Data. [PDF]
Song J, Sui W, Guo H, Li J.
europepmc +1 more source

