Results 131 to 140 of about 7,486,347 (328)
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Jixie qiangduObjectiveAims to investigate the lack of test data and microscopic mechanism analysis of 60Si2CrV spring steel under high-temperature tempering.
FENG Yonghua +8 more
doaj
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
TeshugangThe yield to tensile strength ratio is the important performance index of seamless steel tube for high strength structures. Studied the change law of mechanical properties of S770QL steel （mass fraction） /%： 0.15C，0.28Si，1.30Mn，0.009P，0.003S，0.20Cr，0 ...
Du Kun +4 more
doaj
Deterministic Detection of Single Ion Implantation
Advanced Engineering Materials, EarlyView.Focused ion beam implantation with high detection efficiencies will enable the rapid and scalable fabrication of advanced spin‐based technologies such as qubits. This work presents the detection efficiencies of a wide range of ions implanted into solid‐state hosts, with efficiencies of >90% recorded for ion species and substrate combinations of ...
Mason Adshead +6 more
wiley +1 more source
Surface Properties of Float Glass after Various Types of Heat Treatment
Хімія, фізика та технологія поверхні, 2014 The surface properties of float glass tempered by air and by contact method have been studied. Air tempering was performed by traditional method, contact one was realized by a new method when a glass sample was fixed between the heat conductive plates ...
T. B. Zheplynskyy, O. K. Serkiz
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
Monte Carlo Study of the Phase Structure of Compact Polymer Chains
, 1998 We study the phase behavior of single homopolymers in a simple hydrophobic/hydrophilic off-lattice model with sequence independent local interactions.
Anders Irbäck +2 more
core +3 more sources