Results 101 to 110 of about 8,559,227 (400)
The compounding of short fibre reinforced thermoplastic composites [PDF]
, 1988 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.It is generally accepted that the mechanical properties of short fibre reinforced thermoplastics do not correspond with the high mechanical properties of ...
Shipton, Paul David
core
Aggregate effect on the concrete cone capacity of an undercut anchor under quasi-static tensile load [PDF]
, 2018 In the last decades, fastening systems have become an essential part of the construction industry. Post-installed mechanical anchors are frequently used in concrete members to connect them with other load bearing structural members, or to attach ...
Boumakis, Ioannis +4 more
core +3 more sources
Advanced Engineering Materials, EarlyView.In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk +4 more
wiley +1 more source
Investigation of thermal fatigue in fiber composite materials [PDF]
Graphite-epoxy laminates were thermally cycled to determine the effects of thermal cycles on tensile properties and thermal expansion coefficients of the laminates. Three 12-ply laminate configurations were subjected to up to 5,000 thermal cycles.
Cunningham, T. G., Fahmy, A. A.
core +1 more source
From Nature to Engineering: Mortar Volume and Interfacial Mechanics in Bioinspired Ceramics
Advanced Engineering Materials, EarlyView.Inspired by natural armors like nacre, this study explores how varying the volume fraction of the soft mortar layer impacts the interfacial strength and toughness of bioinspired ceramics. Experimental and computational analysis reveals that higher mortar volumes increase energy dissipation but reduce interfacial stiffness, offering insights for ...
Ehsan Azad +4 more
wiley +1 more source
Creep degradation in oxide-dispersion-strengthened alloys [PDF]
Oxide dispersion strengthened Ni-base alloys in wrought bar form are studied for creep degradation effects similar to those found in thin gage sheet.
Whittenberger, J. D.
core +1 more source
Shape manipulation using physically based wire deformations [PDF]
, 2010 This paper develops an efficient, physically based shape manipulation technique. It defines a 3D model with profile curves, and uses spine curves generated from the profile curves to control the motion and global shape of 3D models.
Au +35 more
core +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing technologies like laser powder‐bed fusion offer great design freedom and individualization of products down to a batch size of one. However, parts fabricated with this technology suffer from poor quality. Acoustic assistance during the build process can minimize these drawbacks.
Oliver Maurer, Dirk Bähre
wiley +1 more source
Test Research of Low Temperature Property of Chain Material
Jixie chuandong, 2016 The tensile tests of LH1034 leaf chains with 45 Mn plates and 35 CrMo pins are conducted under10 ℃ and- 40 ℃ temperature. The Charpy impact test of chain materials of 45 Mn,35CrMo as plate and35 CrMo,40 CrNiMoA with heat treated（ quenching and tempering ...
Lu Jiguang +3 more
doaj
Stress-driven instability in growing multilayer films
, 2003 We investigate the stress-driven morphological instability of epitaxially growing multilayer films, which are coherent and dislocation-free. We construct a direct elastic analysis, from which we determine the elastic state of the system recursively in ...
A. A. Maradudin +42 more
core +1 more source