Results 211 to 220 of about 101,100 (265)

Physicomechanical Performance and Aging Behavior of Polycarbodiimide-Cross-Linked Accelerator-Free Carboxylated Nitrile Butadiene Rubber Latex Gloves. [PDF]

ACS Omega
Wan Azman N, Kamei R, Matsuoka T, Ikeda K, Kubono Y, A Rashid A.   +5 more
europepmc   +1 more source

Study on fracture propagation and evolution characteristics of coal samples under uniaxial compression. [PDF]

Sci Rep
Weibin G, Jiahao Z, Yuhui L, Gang W, Yichen G.   +4 more
europepmc   +1 more source

Human airway material characterization via inverse finite element analysis and neural network surrogate. [PDF]

Biomech Model Mechanobiol
Badrou A, Mariano CA, Nelson TM, Eskandari M.   +3 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Methodical Features of Tensile Testing of Ring Samples

Inorganic Materials: Applied Research, 2020
Experimental and computational studies of the deformation behavior of ring samples under stretching with the use of cylindrical supports have been performed. Methodological errors of this type of testing have been analyzed. The deformation accumulated upon straightening a ring sample and also the gauge length thereof depending on the dimensions of the ...
M. V. Leontieva-Smirnova, B. A. Kalin, E. M. Morozov, A. V. Kostyukhina, P. V. Fedotov, R. N. Taktashev   +5 more
openaire   +1 more source

Simulation Analysis of the Tensile Process on Sheet Sample

Applied Mechanics and Materials, 2011
Stress-strain is commonly used in engineering; however the real stress-strain is more used in the test and exploitation of new product. ANSYS finite element software is adopted in this study, stress-strain of the tensile sample of the sheet in different stage is calculated under the 10mm displacement load, stress-strain curve is obtained, and the ...
Yin Lan Bai, Da Yong You, Guo Qing Lu, Chen Xin Liu   +3 more
openaire   +1 more source

Tensile strength from imperfect samples

Journal of Materials Science Letters, 1988
It is often necessary to carry out tensile strength tests on fibre cement composite samples cut from a flat sheet in the as-received condition where further sample preparation is undesirable. Very often the sample coupons show defects such as bowing. These imperfections are most noticeable for materials which fail at low strains, such as some of the ...
openaire   +1 more source