Control Parameters and Materials Selection Criteria for Rapid Prototyping Systems [PDF]
, 1993 Since the introduction ofrapid prototyping technology as a tool for time compression and concurrent engineering in the design and manufacturing process, many enhancements and refinements have been made based on the experience ofusers and manufacturers
Comb, James W., Priedman, William R.
core +1 more source
Mechanical Properties of the Mineral Cast Material at the Macro and Micro Level. [PDF]
, 2016 The paper presents the results of experimental examination of the mechanical properties at micro and macro scale of the mineral cast composites. Studies have been conducted to verify the literature data about the value of tensile strength, compressive ...
Kaczmarek, Łukasz +3 more
core
Tensile & shear strength of porous dust agglomerates
, 2013 Context.Within the sequential accretion scenario of planet formation, planets are build up through a sequence sticking collisions. The outcome of collisions between porous dust aggregates is very important for the growth from very small dust particles to
Kley, Wilhelm +2 more
core +1 more source
Fracture strength and Young's modulus of ZnO nanowires [PDF]
, 2006 The fracture strength of ZnO nanowires vertically grown on sapphire substrates was measured in tensile and bending experiments. Nanowires with diameters between 60 and 310 nm and a typical length of 2 um were manipulated with an atomic force microscopy ...
Ballif, C. +6 more
core +2 more sources
An ex vivo comparison of the tensile strengthening properties of protein derivatives on damaged hair [PDF]
, 2015 Conventional conditioning agents, cationic surfactants and polymers, are often limited in their ability to repair and strengthen the hair fibre, while protein-derived actives have been found to enhance the tensile strength of damaged hair.
Daniels, Gabriela +3 more
core +1 more source
Tensile strength of the pipe material determination according to the ultimate tensile strength
IOP Conference Series: Materials Science and Engineering, 2020 Abstract A new calculation method for the strength of concrete pipes, developed, helps to determine the stresses in the walls of concrete pipes under the combined action of an external (compressing pipe) load and internal pressure from the fluid transported under pressure.
L. Saienko +3 more
openaire +2 more sources
Tensile strength of cohesive powders
Advanced Powder Technology, 2019 Measurement and prediction of cohesive powder behaviour related to flowability, flooding or arching in silos is found to be very challenging. Previous round robin attempts with ring shear testers did not furnish reliable data and have shown considerable degrees of scatter and uncertainty in key measurements.
García-Triñanes, Pablo +2 more
openaire +3 more sources
High-temperature tensile tester for ceramics [PDF]
, 1974 Apparatus measures tensile strength of rigid, low-density ceramic materials at temperatures up to 1375 K. Tensile grips mate with tensile specimen and form top and bottom of lightweight furnace.
Smith, M.
core +1 more source
The effects of high-temperature brazing and thermal cycling on the mechanical properties of Hastelloy X [PDF]
, 1972 Data are presented on the effects of brazing alloy, brazing operation, thermal cycling, and combinations of these on the yield strength, elongation, tensile strength, and fatigue life of thin gage Hastelloy X. These data show that brazing at 1461 K (2170
Buckley, J. D., Dicus, D. L.
core +1 more source
Strength Properties of Preceramic Brazed Joints of a Gold-Palladium Alloy with a Microwave-assisted Oven and Gas/Oxygen Torch Technique [PDF]
, 2014 Statement of problem The effect of microwave brazing on the strength properties of dental casting alloys is not yet known. Purpose The purpose of this study was to compare the strength properties of preceramic brazed joints obtained by using a microwave
Dunford, Robert +3 more
core +1 more source