Results 11 to 20 of about 281,971 (191)

Self-powered ammonia synthesis under ambient conditions via N2 discharge driven by Tesla turbine triboelectric nanogenerators [PDF]

open access: yesMicrosystems & Nanoengineering, 2021
Ammonia synthesis using low-power consumption and eco-friendly methods has attracted increasing attention. Here, based on the Tesla turbine triboelectric nanogenerator (TENG), we designed a simple and effective self-powered ammonia synthesis system by N2
Kai Han   +7 more
doaj   +2 more sources

A new type of bladeless turbine for compressed gas energy storage system [PDF]

open access: yesFrontiers in Chemistry, 2022
Nowadays, energy storage engineering is an important means to relieve the problem of energy shortage. In this investigation, we design a kind of vaneless turbine originating from a Tesla turbine with a diameter and an air gap of 250 mm and 0.5 mm ...
Qin Wang   +3 more
doaj   +2 more sources

Monolithically 3D-Printed Microfluidics with Embedded µTesla Pump [PDF]

open access: yesMicromachines, 2023
Microfluidics has earned a reputation for providing numerous transformative but disconnected devices and techniques. Active research seeks to address this challenge by integrating microfluidic components, including embedded miniature pumps.
Kai Duan   +6 more
doaj   +2 more sources

Experimental evaluation of a cost-effective tesla turbine for waste air energy recovery in transportation systems [PDF]

open access: yesScientific Reports
Waste energy recovery from mechanical systems represents a promising approach for improving energy utilization in transportation applications. In air brake systems used in heavy-duty vehicles and railway trains, a considerable amount of compressed air is
Mohamed B. Farghaly   +5 more
doaj   +2 more sources

Computational Fluid Dynamic Analysis of the Tesla Turbine [PDF]

open access: yes, 2016
Serbian-born inventor Nikola Tesla invented the Tesla turbine and patented it in 1913. The Tesla turbine is unique in the sense that it does not have any blades, also referred to as “bladeless turbine”. The working was based on the establishment of the fluid boundary layer. The original Tesla turbine consisted of multiple smooth discs. With the passage
Strand, Cathrine   +2 more
openaire   +3 more sources

1D MODEL CALIBRATION BASED ON 3D CALCULATIONS FOR TESLA TURBINE [PDF]

open access: yesTASK Quarterly, 2010
This paper presents a system of equations for an axisymmetric laminar flow, after averaging, through the width of the interdisk slit of a Tesla turbine. Coefficients improving the efficiency of a 1D model were introduced as a result of averaging.
ROMUALD PUZYREWSKI, KRZYSZTOF TESCH
doaj   +1 more source

A revised Tesla Turbine concept for 2-phase applications [PDF]

open access: yesE3S Web of Conferences, 2021
The Tesla turbine is an original expander working on the principle of torque transmission by wall shear stress. The principle – demonstrated for air expanders at lab scale has some attractive features when applied to two-phase expanders: it is suitable ...
Talluri L.   +10 more
doaj   +1 more source

Design and off-design analysis of a Tesla Turbine utilizing CO2 as working fluid [PDF]

open access: yesE3S Web of Conferences, 2019
The Tesla turbine is a bladeless expander; which principle of operation is based on the conversion of the viscous forces, developed by the flow while expanding through the rotor, in mechanical energy.
Fiaschi Daniele, Talluri Lorenzo
doaj   +1 more source

Design, Construction and Simulation of Tesla Turbine

open access: yesInternational Journal of Engineering and Management Research, 2021
Investigations of laminar fluid flow between two moving or stationary plates, and two rotating discs, over the years were geared toward how to increase Tesla-based turbine efficiency. Therefore, this research entails the construction, design and simulation of a Tesla turbine in order to investigate the potential of Tesla turbine for energy generation ...
, SMG Akele   +5 more
openaire   +2 more sources

Micro-turbine applied to seismology: towards a power supply safe from lightning [PDF]

open access: yesE3S Web of Conferences, 2019
The present work aims to suggest an innovative solution for seismic monitoring stations’ endurance. These stations are characterized by many different problems, such as lightning vulnerability, energy independence and noises disturbance.
Scafidi Davide   +7 more
doaj   +1 more source

Home - About - Disclaimer - Privacy