Results 41 to 50 of about 56,882 (308)
Energy and Built EnvironmentAs the improvement of district heating systems, the fine-tuning of operational equipment has become a promising direction. However, in the practical district heating systems, relying solely on manual control and the existing basic models, the dynamic ...
Xiaojie Lin +4 more
doaj +1 more source
Proceedings of the International Conference on Applied Innovations in IT, 2023 Efficient conversion of solar energy into electrical and thermal energy has become a major goal of researchers around the world. In this regard, the authors have developed photovoltaic thermal installations to efficiently convert solar energy into ...
Isroil Yuldoshev +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley +1 more source
Advanced spreadsheet based methodology for the dynamic thermal modelling of buildings [PDF]
, 2006 This thesis was submitted for the degree of Doctor of Philosophy and was awarded by Brunel University.Thermal analysis of buildings was carried out using simplified design tools, prior to the widespread use of computers.
Demetriou, Louis
core
An assessment of the CORCON-MOD3 code. Part 1: Thermal-hydraulic calculations [PDF]
, 1996 This report deals with the subject of CORCON-Mod3 code validation (thermal-hydraulic modeling capability only) based on MCCI (molten core concrete interaction) experiments conducted under different programs in the past decade. Thermal-hydraulic calculations (i.e., concrete ablation, melt temperature, melt energy, concrete temperature, and condensible ...
Strizhov, V. +4 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
International Journal of Advanced Nuclear Reactor Design and Technology, 2021 Blankets are of practical importance in the fusion reactor due to their main functions for engineering application. As the fusion power designed for the Chinese Fusion Engineering Test Reactor (CFETR) is increased from 200 MW to 1.5 GW during its phase ...
Qiang Lian +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This work shows that the mechanical performance of multimaterial digital light processing (DLP) printed thermoset composites is governed by resin compatibility and interfacial design rather than spatial patterning alone. Brittle and ductile resin combinations produced premature interfacial failure, while graded interfaces and mechanically compatible ...
Ahmed M. H. Ibrahim +3 more
wiley +1 more source
Thermal-hydraulic calculation of heat exchanger
, 2019 This bachelor thesis deals with thermal-hydraulic calculation of heat exchanger. The first part describes the basic types of heat exchangers considering their construction and utilization.
Zemach, Vít
core +1 more source
EPJ Nuclear Sciences & Technologies, 2015 The purpose of this paper is to model the operation of the Shutdown Cooling System (SDCS) for CANDU 6 nuclear power plants in case of LOCA accidents, using Flowmaster calculation code, by delimiting models and setting calculation assumptions, input data ...
Icleanu Diana Laura +2 more
doaj +1 more source