Effect of infill parameters and thermal annealing on the mechanical behavior of FDM 3D-printed polymer. [PDF]
Sci RepNassar A +4 more
europepmc +1 more source
An Experimental High‐Throughput Approach for the Screening of Hard Magnet Materials
Advanced Engineering Materials, EarlyView.An entire workflow for the high‐throughput characterization and analysis of compositionally graded magnetic films is presented. Characterization protocols, data management tools and data analysis approaches are illustrated with test case Sm(Fe, V)12 based films.
William Rigaut +16 more
wiley +1 more source
Relation Between Thermal Analysis, Phase Composition and Structure of Polyurethane Adhesives for Application in Wooden Structural Joints. [PDF]
Polymers (Basel)Szumera M +8 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This study reports the development of antibacterial ceramic scaffolds derived from natural bovine bone. The bones were processed through sequential boiling and hydrogen peroxide treatment to remove organic matter, producing porous, mineral‐rich scaffolds.
Mohamad Hassan Taherian +6 more
wiley +1 more source
Investigation of Temperature-Field Evolution and Microstructural Response in Bituminous Waterproofing Membranes Under Low-Temperature Flexibility Testing Conditions. [PDF]
Polymers (Basel)Tan J, Geng L, Zhang D, Li C, Zhang C.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
A Sub-Milliwatt Graphene-Based Thermal Conductivity Detector for On-Site Gas Analysis. [PDF]
Sensors (Basel)Sium FS +7 more
europepmc +1 more source
Nondestructive Testing of Welded Composite Metal Foams
Advanced Engineering Materials, EarlyView.X‐ray computed tomography (CT) is used to evaluate welded steel–steel composite metal foam (CMF) joints of two density classes. It reports variation in postweld spatial void distribution and correlates it to weld‐induced changes, mechanical performance, and failure within welded CMF panels.
Chinmaya Prerana Inguva +2 more
wiley +1 more source
Computational insight to optimize nanofluidic thermal transport management in octagonal enclosure with heat generating element by envisioning novel physical factors. [PDF]
Discov NanoUllah A, Khan NZ, Bilal S, Riaz MB.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source