Results 191 to 200 of about 1,137,079 (315)

Transverse Mode Instability in High-Power Yb-Doped Double-Clad Fiber Amplifiers: A Three-Layer Optical-Thermal Analysis Based on Stimulated Thermal Rayleigh Scattering. [PDF]

Micromachines (Basel)
Cardoso ES, Samad RE, Motta CC.
europepmc   +1 more source

Fostering Innovation: Streamlining Magnetocaloric Materials Research by Digitalization

Advanced Engineering Materials, EarlyView.
Magnetocaloric cooling (MCE) is an environmentally friendly refrigeration method with great potential. Optimizing MCE materials involves the preparation and screening of large quantities of samples, which in turn generates a large amount of data. A digitalization approach is presented that uses ontologies, knowledge graphs, and digital workflows to ...
Simon Bekemeier, Moritz Blum, Luana Caron, Alisa Chirkova, Philipp Cimiano, Basil Ell, Inga Ennen, Michael Feige, Maik Gaerner, Thomas Hilbig, Andreas Hütten, Günter Reiss, Tapas Samanta, Sonja Schöning, Christian Schröder, Lennart Schwan, Chris Taake, Martin Wortmann   +17 more
wiley   +1 more source

Integrated Microcantilever for Joint Thermal Analysis of Trace Hazardous Materials. [PDF]

Sensors (Basel)
Yang Y, Li X, Li Z, Li M, Chen Y, Tan S, Yu H, Xu P, Li X.   +8 more
europepmc   +1 more source

Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys

Advanced Engineering Materials, EarlyView.
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak, Olha Zvirko, Rostyslav Leshchak, Hryhoriy Nykyforchyn   +3 more
wiley   +1 more source

Preliminary study on the dynamic mechanical thermal analysis of polymer foams for use in impact resistant systems design. [PDF]

Sci Rep
Fejdyś M, Klich M, Cichosz S, Kudlińska M.   +3 more
europepmc   +1 more source

Tailoring Functional Properties of Ti–Ni–Cu Shape Memory Alloy Thin Films for MEMS Actuators

Advanced Engineering Materials, EarlyView.
A comprehensive study of critical parameters required to develop well‐performing Ti–Ni–Cu thin film shape memory alloy microactuators is provided. Materials science and device integration aspects are integrated by addressing structural and physical relationships using complementary characterization techniques as well as a practical fabrication solution
Elaheh Akbarnejad, Aleksander Kostka, Gowtham Arivanandhan, Yujiao Li, Alan Savan, Manfred Kohl, Alfred Ludwig   +6 more
wiley   +1 more source

Activation Characteristics and Aluminum Recovery from Coal Gangue: Structure-Phase-Reactivity Relationships Revealed by Thermal Analysis, Kinetics, and Acid Leaching. [PDF]

ACS Omega
Du H, Li K, Li T, Shi X, Fang L, Cao Z.
europepmc   +1 more source

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

Advanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang, Aparajita Pramanik, Sandipan Sen, Shubhashis Dixit, Marcel Muench, R. J. Vikram, Daniel Schliephake, Yolita M. Eggeler, Ankur Chauhan, Martin Heilmaier, Alexander Kauffmann   +10 more
wiley   +1 more source

Machine learning-assisted thermal analysis of propylene glycol nanofluid with dual flux and bioconvection over a Riga plate. [PDF]

Sci Rep
Aslam MN, Ali A, Junaid MS, Saeed ST, Almehizia AA, Merga FE.   +5 more
europepmc   +1 more source

THE THERMAL ANALYSIS OF URINARY CALCULI

The Japanese Journal of Urology, 1982
openaire   +3 more sources