Results 151 to 160 of about 8,347,297 (348)

Insight into the Enhanced Removal of Water from Coal Slime via Solar Drying Technology: Dewatering Performance, Solar Thermal Efficiency, and Economic Analysis. [PDF]

ACS Omega, 2022
Guo X, Li K, Zhou P, Liang J, Gu JN, Xue Y, Guo M, Sun T, Jia J.   +8 more
europepmc   +1 more source

What fuel properties enable higher thermal efficiency in spark-ignited engines?

, 2021
J. Szybist, S. Busch, R. McCormick, J. Pihl, D. Splitter, M. Ratcliff, Christopher P. Kolodziej, J. Storey, Melanie Moses-DeBusk, D. Vuilleumier, Magnus Sjöberg, C. Sluder, T. Rockstroh, P. Miles   +13 more
semanticscholar   +1 more source

Methods for Improvement of the Thermal Efficiency during Spray Drying

, 2018
Spray drying is a kind of unit operation with high energy consumption and relatively low energy utilization, and the problem of low thermal efficiency has been attracted the attention by scholars at home and abroad.
Fang Cheng, Xueyong Zhou, Yanmei Liu
semanticscholar   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Integrated photovoltaic-thermal solar energy conversion systems [PDF]

A combined photovoltaic/thermal collector has been built and is now being tested. Initial tests have concentrated on evaluating the thermal efficiency of the collector before and after the silicon cells are mounted.
Samara, G. A.
core   +1 more source

Watching the Smoke Rise Up: Thermal Efficiency, Pollutant Emissions and Global Warming Impact of Three Biomass Cookstoves in Ghana

, 2017
In Ghana, about 73% of households rely on solid fuels for cooking. Over 13,000 annual deaths are attributed to exposure to indoor air pollution from inefficient combustion.
G. Obeng, E. Mensah, George Ashiagbor, O. Boahen, Daniel J. Sweeney   +4 more
semanticscholar   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

Enhanced Ventilation and Energy Efficiency of an Optimized Double-Channel Solar Chimney

Buildings
This study explores the use of solar chimneys to harness solar radiation, generating a chimney effect that promotes natural ventilation in buildings. However, the performance of double-channel solar chimneys is heavily influenced by their installation ...
Chenle Ye, Yanfei Zhang, Qinming Lv, Shaoyang Lou, Xiaojun Luo, Zhonggou Chen, Guoyi Zhang   +6 more
doaj   +1 more source

Evaluation of two designs for cryogenic insulation [PDF]

, 1970
Shingle-type, crinkled, aluminized polyethylene ester is thermally and structurally tested for cryogenic insulation. Insulation systems require thermal efficiency with minimum weight, and the ability to withstand vibration, acceleration, and rapid ...
Getty, R. C.
core   +1 more source

Engineering Deformation and Failure in Diamond Triply Periodic Minimal Surface Lattices via 3D Wall‐Thickness Grading

Advanced Engineering Materials, EarlyView.
The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza, Danilo Bruson, Manuela Galati, Luca Iuliano   +3 more
wiley   +1 more source