Results 91 to 100 of about 6,644,988 (309)
FireTo investigate resistance change in the fire area of a roadway caused by roadway fires, a mathematical calculation model for thermal resistance is developed.
Minghao Ni +5 more
doaj +1 more source
Journal of Applied Sciences and Environmental Management, 2019 It is well known that the physics of thermal management is quite challenging as electronic device sizes are miniaturized and new materials are developed.
O.N. Nenuwe, O.E. Agbalagba
doaj +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
FibersIn diabetic patients, optimised plantar health necessitates meticulously designed hosiery. These specialised socks facilitate a healthy microclimate at the skin–textile interface.
Adine Gericke, Mohanapriya Venkataraman
doaj +1 more source
Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects
Advanced Engineering Materials, EarlyView.This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
, 2017 The in-plane and cross-plane thermal conductivity of polycrystalline diamond near its nucleation region have been measured by Raman thermography assisted by TiO 2 nanoparticles and by picosecond time-domain thermoreflectance (TDTR).
Julian Anaya +14 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
Zhileng xuebaoThis study experimentally investigates the impact of flow resistance in risers and downcomers on the heat transfer performance of two-phase thermosyphon loops (TPTLs) with CO2, R134a, and R410A refrigerants.
Tong Zhen +4 more
doaj