Results 11 to 20 of about 319,182 (267)

Effect of Interfacial Thermal Resistance in a Thermal Cloak [PDF]

open access: yesPhysical Review Applied, 2020
When heat transfers through interface between two different materials, it will encounter an interfacial thermal resistance (ITR) that makes the temperature discontinuous. This effect has been totally neglected so far in the research of thermal cloak, in particular when the thermal cloak is built with multilayer structures. In this paper, we investigate
Xu Zheng, Baowen Li
openaire   +2 more sources

Thermal Resistance Distribution Experiment of Parallel Sub-Module in Press-Pack IGBT Device

open access: yesZhongguo dianli, 2020
In the rigid Press-Pack IGBT module, the pressure distribution of parallel chips determines the contact thermal resistance and contact electrical resistance directly.
Lubin HAN, Lin LIANG, Yong KANG
doaj   +1 more source

Energy Efficiency of a Wooden House

open access: yesTehnički Glasnik, 2020
An exemplary construction project developed in a commune close to Constanta, Romania, aims to build wooden houses for families with low income. The study focuses on their energy performance, aiming to determine simple technical solutions for the ...
Anca Constantin
doaj   +1 more source

Thermal Death Kinetics of Three Representative Salmonella enterica Strains in Toasted Oats Cereal

open access: yesMicroorganisms, 2022
Several reports have indicated that the thermal tolerance of Salmonella at low-water activity increases significantly, but information on the impact of diverse food matrices is still scarce.
Matthew Chick   +4 more
doaj   +1 more source

Thermal conductivity and thermal boundary resistance of nanostructures [PDF]

open access: yesNanoscale Research Letters, 2011
Abstract Abstract We present a fabrication process of low-cost superlattices and simulations related with the heat dissipation on them. The influence of the interfacial roughness on the thermal conductivity of semiconductor/semiconductor superlattices was studied by equilibrium and non-equilibrium molecular dynamics and ...
Termentzidis, K.   +9 more
openaire   +4 more sources

Influence of Zinc Oxide Nanoparticles on Flame Resistance in Wood Plastic Composites

open access: yesDrvna Industrija, 2023
The interest in wood plastic composites (WPCs) has increased in recent years. The utilization of environmentally friendly materials has been of great significance due to the overwhelming pressure on nature. As a widely used material, plastic is, however,
Sefa Durmaz   +5 more
doaj   +1 more source

Influence of a Cooling System on Power MOSFETs’ Thermal Parameters

open access: yesEnergies, 2022
In the current paper, an analysis of the influence of cooling system selection on the thermal parameters of two thermally coupled power MOSFETs is presented. The required measurements of the thermal parameters were performed using the indirect electrical
Krzysztof Górecki   +1 more
doaj   +1 more source

Expression of ompR gene in the acid adaptation and thermal resistance of Salmonella Enteritidis SE86

open access: yesJournal of Infection in Developing Countries, 2014
Introduction: The objective of this study was to evaluate the involvement of the ompR gene in the acid adaptation and thermal resistance of S. Enteritidis SE86, responsible agent of more than 95 % of investigated food-borne diseases, throughout the last ...
Ana Carolina Ritter   +5 more
doaj   +1 more source

Effects of Die-Attach Quality on the Mechanical and Thermal Properties of High-Power Light-Emitting Diodes Packaging

open access: yesAdvances in Materials Science and Engineering, 2017
The reliability of high-power light-emitting-diode (LED) devices strongly depends on the die-attach quality because voids may increase junction temperature and total thermal resistance of LED devices.
Piaopiao He   +3 more
doaj   +1 more source

ASYMMETRIC SLOT LINES FOR CREATING MILLIMETER-WAVE SEMICONDUCTOR COMPONENTS [PDF]

open access: yesRadio Physics and Radio Astronomy
Subject and Purpose. Creating hybrid-integrated semiconductor components in the millimeter wave range implies simplified manufacturing technology and reduced labor intensity.
M. F. Karushkin, V. P. Rukyn
doaj   +1 more source

Home - About - Disclaimer - Privacy