Results 221 to 230 of about 323,013 (267)
Some of the next articles are maybe not open access.
International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 1984
Information on the thermal properties of soils from different disciplines of science and engineering is consolidated to identify low-cost, simple procedures for assessing the variation of the thermal resistivity of soils with changes in moisture content. Three procedures for determining the critical moisture content are presented. The critical moisture
Lawrence A. Salomone, William D. Kovacs
openaire +2 more sources
Information on the thermal properties of soils from different disciplines of science and engineering is consolidated to identify low-cost, simple procedures for assessing the variation of the thermal resistivity of soils with changes in moisture content. Three procedures for determining the critical moisture content are presented. The critical moisture
Lawrence A. Salomone, William D. Kovacs
openaire +2 more sources
AIChE Journal, 1957
AbstractBy experimental means a relation is obtained between the thermal resistance of an eddy and its angular momentum. The eddy is stationary, and no extraneous motion is present. The secondary motion which may develop in the annulus between concentric rotating cylinders is used to obtain the eddies.
L. G. Clark, W. W. Hagerty
openaire +1 more source
AbstractBy experimental means a relation is obtained between the thermal resistance of an eddy and its angular momentum. The eddy is stationary, and no extraneous motion is present. The secondary motion which may develop in the annulus between concentric rotating cylinders is used to obtain the eddies.
L. G. Clark, W. W. Hagerty
openaire +1 more source
Antibiotic resistance in the patient with cancer: Escalating challenges and paths forward
Ca-A Cancer Journal for Clinicians, 2021Amila Nanayakkara, David Greenberg
exaly
Thermal Constriction Resistance
1996It was seen in Chapter 1 that the contact interface consists of a number of discrete and small actual contact spots separated by relatively large gaps. These gaps may be either evacuated or filled with a conducting medium such as gas. In the first case, all of the heat flow lines are constrained to pass through the contact spots. If the gaps are filled
openaire +1 more source