Results 11 to 20 of about 2,554,272 (326)
Use thermophysical property to quantify state of HIFU treatment for VLS [PDF]
E3S Web of Conferences, 2020 The aim of this study is to evaluate the performance of ADT methods in grading the effectiveness of HIFU treatment for VLS. High-intensity focused ultrasound has been identified as a promising treatment modality for vulvar lichen sclerosus, a common ...
Feng Sui +3 more
doaj +1 more source
Heat transfer analysis of Maxwell hybrid nanofluid with fractional Cattaneo heat flux
Alexandria Engineering Journal, 2023 Hybrid nanofluids are widely used to improve the efficiency of a thermal system in many aspects of engineering and science. Therefore, the current work is design to investigate the heat transfer of Cu-Fe3O4 nanoparticles in water base Maxwell fluid flow ...
Hanifa Hanif +3 more
doaj +1 more source
Isopods failed to acclimate their thermal sensitivity of locomotor performance during predictable or stochastic cooling. [PDF]
PLoS ONE, 2011 Most organisms experience environments that vary continuously over time, yet researchers generally study phenotypic responses to abrupt and sustained changes in environmental conditions.
Matthew S Schuler +4 more
doaj +1 more source
Agriculture, 2015 Thermal-based germination models are widely used to predict germination rate and germination timing of plants. However, comparison of model parameters between large numbers of species is rare. In this study, seeds of 27 species including 12 C4 and 15 C3
Hongxiang Zhang, Yu Tian, Daowei Zhou
doaj +1 more source
Experimental study of the thermochemical treatment of the low-grade coal prior to boiler combustion at coal-fired power station [PDF]
E3S Web of Conferences, 2019 Analysis of the perspectives of the coal fuel for thermal power plants is carried out. The necessity of the experimental study for temperature measurement in the boiler furnace. The results of the experimental study are presented: temperature change over
Yemelianenko Volodymyr +4 more
doaj +1 more source
Frontiers in Bioengineering and Biotechnology, 2023 The mechanical properties of polyurethane dental aligners have been studied in an oral environment at 37°C and subjected to thermal cycling between 5°C and 55°C for long periods of time at different mechanical stresses.
Patricia Cintora-López +5 more
doaj +1 more source
Physics in turkey cooking: Revisit the Panofsky formula
AIP Advances, 2021 Back in 2008, Panofsky gave an empirical formula, T=11.5W2/3, for turkey baking time, T, in hours vs turkey weight, W, in pounds, the so-called Panofsky formula or Panofsky constant. Compared to the previously existed recipes that are based on the simple
Yifei “Jenny” Jin +2 more
doaj +1 more source
Energy Reports, 2022 According to the characteristics of electromagnetic thermal energy storage, the full-bridge inverter and resonant circuit with simple structure, high voltage utilization and high output power are used in this paper.
Xiaoju Yin +5 more
doaj +1 more source
, 2022 The design of a building's exterior walls has an important influence on energy consumption, building cost and thermal comfort. It influences also heating and cooling devices’ size. Optimization of energy consumption of the building requires consideration of the building materials, their thickness and mass, type and thickness of insulation, and location
openaire +1 more source
Thermalization of magnetically trapped metastable helium [PDF]
, 2001 We have observed thermalization by elastic collisions of magnetically trapped metastable helium atoms. Our method directly samples the reconstruction of a thermal energy distribution after the application of an RF knife. The relaxation time of our sample
Aspect, A. +7 more
core +2 more sources