Results 81 to 90 of about 2,554,272 (326)
Advanced Engineering Materials, EarlyView.Microstructural evolution and hardness optimization along the cross‐section of friction stir welded AA6061/AlSi10MgMn joints, for electric vehicle battery housings, were investigated. Postweld aging between 170°C and 220°C enhances hardness uniformity within the nugget zone.
Emanuele Ghio, Emanuela Cerri
wiley +1 more source
Advanced Engineering Materials, EarlyView.A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann +2 more
wiley +1 more source
Determination of Greenhouse Time Constant Using Steady-state Assumption [PDF]
, 2004 A study was conducted to determine the applicability of a steady-state solution in predicting the changes in temperatures of the inside air and thermal mass of a bench-top-heated greenhouse in response to a step change in outside temperature.
Janius, Rimfiel, M. Jenkins, Bryan
core
Self-organization in He4 near the superfluid transition in heat flow and gravity
, 2010 We investigate the nonlinear dynamics of He4 slightly below the superffluid transition by integrating model F equations in three dimensions. When heated from above under gravity, a vortex tangle and a sheetlike phase slip are generated near the bottom ...
A. Onuki +8 more
core +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
Temperature Dependent Motion of a Massive Quantum Particle
, 2011 We report model calculations of the time-dependent internal energy and entropy for a single quasi-free massive quantum particle at a constant temperature.
Peng, Jian-Ping
core +2 more sources
Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study
Advanced Engineering Materials, EarlyView.This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud +7 more
wiley +1 more source
Journal of Nigerian Society of Physical SciencesThis study aims to enhance the thermal stability and dielectric properties of an epoxy/phenolic resin-type novolac blend by incorporating carbon nanofibers (CNFs). The EP/novolac-CNF composite was created by dispersing a 10% weight fraction of CNFs into
Elsammani Ali Shokralla
doaj +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source