Results 51 to 60 of about 77,185 (337)

Air Temperature Measurement Using Thermocouple [PDF]

open access: yes, 1995
P(論文)This research, through experiments on influences of the solar radiation and radiation from surrounding objects, which can cause errors during air temperature measurement using a thermocouple, has made clear the effects of the solar-radiation shield ...
42663, 小林, 定教
core   +1 more source

High-temperature irradiation-resistant thermocouple instability model for in-pile reactor use

open access: yesFrontiers in Energy Research, 2023
This article presents an instability model for the high-temperature irradiation-resistant thermocouple (HTIR-TC). Here the term instability defines the superposition of both drift and inhomogeneity of TC thermoelements occurring simultaneously.
Richard Skifton
doaj   +1 more source

Performance Analysis of Abradable Coating Systems for Aircraft Gas Turbines

open access: yesAdvanced Engineering Materials, EarlyView.
Three CoNiCrAlY/YSZ/MgAl2O4 abradable liner configurations on a nickel‐superalloy are evaluated by thermal‐gradient cycling and incursion tests. Laser ablation of the bondcoat and/or Y2O3‐stabilized ZrO2 (YSZ) intermediate layer increases mechanical interlocking and bonding for thick topcoats.
Hanna Heyl   +4 more
wiley   +1 more source

A Note on Grounded Thermocouple Circuits [PDF]

open access: yes, 1972
Basic circuits involving the thermocouple as a temperature-sensing device have been described and analyzed in the literature. However, relatively little has been written on the thermocouple as part of an overall instrument circuit wherein external ...
R. P. Benedict, R. J. Russo
core   +1 more source

Time‐Dependent Oxidation and Scale Evolution of a Wrought Co/Ni‐Based Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
This study shows how a new wrought Co/Ni‐based superalloy resists oxidation at 800 ∘$^\circ$C. The oxide scale changes from rough, fast‐growing spinel to a dense, protective chromia–alumina layer. Atom probe analysis reveals tiny refractory‐rich bubbles at the interface that mark the transition to long‐term, diffusion‐controlled protection ...
Cameron Crabb   +6 more
wiley   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat   +5 more
wiley   +1 more source

Enhancing the Accuracy of Advanced High Temperature Mechanical Testing through Thermography

open access: yesApplied Sciences, 2018
This paper describes the advantages and enhanced accuracy thermography provides to high temperature mechanical testing. This technique is not only used to monitor, but also to control test specimen temperatures where the infra-red technique enables ...
Jonathan Jones
doaj   +1 more source

Nonnegligible Temperature Drop Induced by Thermocouple on Samples in Gleeble Tests

open access: yesMetals, 2023
High-temperature plastic deformation is one of the main methods for the fabrication of titanium-based alloys. Accurate determination of the mechanical constitutive relation is pivotal for the design, optimization, as well as the prediction of the ...
Xiuhong Zhao   +5 more
doaj   +1 more source

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han   +5 more
wiley   +1 more source

Fabrication and Characterization of Flexible Thermoelectric Generators Using Micromachining and Electroplating Techniques

open access: yesMicromachines, 2019
This study involves the fabrication and measurement of a flexible thermoelectric generator (FTG) using micromachining and electroplating processes. The area of the FTG is 46 × 17 mm2, and it is composed of 39 thermocouples in series.
Wnag-Lin Lee   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy