Results 81 to 90 of about 3,496,599 (369)

The Nonlinear Visco‐Hyperelastic Damage Mechanics of Individual Electrospun Polycaprolactone Fibers: Experiments and Modeling

Advanced Engineering Materials, EarlyView.
This study investigates the complex mechanics of individual electrospun polycaprolactone fibers under small and large strains. Combining experiments with a visco‐hyperelastic damage model, this work reveals and quantifies these fibers’ nonlinear behavior, including strain‐stiffening, viscoelasticity, and damage.
Sascha L. Granhold, Alberto Madariaga, Matthew J. Lohr, Sarah Jones, Andrew J. Robinson, Elizabeth Cosgriff‐Hernandez, Emma Lejeune, Berkin Dortdivanlioglu, Manuel K. Rausch   +8 more
wiley   +1 more source

Optimization of ocean thermal energy conversion based on pressure energy recovery of ammonia water working medium

Frontiers in Energy Research
Ocean thermal energy conversion is a new energy technology that utilizes the temperature difference conditions of seawater to generate electricity. This paper focuses on the closed cycle of ocean thermal energy conversion using ammonia as the working ...
Mingqian Tian, Yanni Yu, Yunxing Hou, Yun Chen, Li Zhang, Yanjun Liu, Yanjun Liu   +6 more
doaj   +1 more source

A concept of a supercritical CO2 Brayton and organic Rankine combined cycle for solar energy utilization with typical geothermal as auxiliary heat source: Thermodynamic analysis and optimization

Energy Reports, 2022
This paper presents an investigation of a supercritical CO2 Brayton and organic Rankine (sCO 2-ORC) combined cycle for solar energy utilization. This combined cycle uses typical geothermal as auxiliary heat source to enhance its thermodynamic performance.
Yue Cao, Peiyu Li, Zongliang Qiao, Shaojun Ren, Fengqi Si   +4 more
doaj  

Development of a Semi-Empirical Model for Estimating the Efficiency of Thermodynamic Power Cycles

Sci, 2023
Power plants constitute the main sources of electricity production, and the calculation of their efficiency is a critical factor that is needed in energy studies.
Evangelos Bellos
doaj   +1 more source

Bunsen section thermodynamic model for hydrogen production by the sulfur-Iodine cycle [PDF]

, 2009
A model for the Bunsen section of the Sulfur – Iodine thermo-chemical cycle is proposed, where sulfur dioxide reacts with excess water and iodine to produce two demixing liquid aqueous phases (H2SO4 rich and HI rich) in equilibrium.
Baudouin, Olivier, Borgard, Jean-Marc, Carles, Philippe, Floquet, Pascal, Gerbaud, Vincent, Hadj-Kali, Mohamed, Joulia, Xavier, Lovera, Patrick   +7 more
core   +2 more sources

Assessing the Microstructure of SnBiZn Alloys during Semisolid Treatment

Advanced Engineering Materials, EarlyView.
The development of Sn‐based alloys for semisolid processing is crucial for Industry 4.0. This study investigates Sn40Bi and Sn40Bi2Zn alloys, revealing that Zn refines Sn‐rich globules by pinning dendrite boundaries. Bi saturation occurs at 60 min, while Zn enhances globule microhardness at 90 min through solid solution strengthening.
Carolina de Siqueira Simioli, Guilherme Lisboa de Gouveia, José Eduardo Spinelli   +2 more
wiley   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

Advanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen, Benjamin Bohne, Sven Winter, Marcus Böhme, Martin F.-X. Wagner   +4 more
wiley   +1 more source

Preparation and Thermal Modification of Disentangled Ultrahigh‐Molecular‐Weight Polyethylene Particles for Powder‐Based Additive Manufacturing

Advanced Engineering Materials, EarlyView.
Ultrahigh‐molecular‐weight polyethylene powders (<≈40 μm) with a bulk density of 260 g L−1 are prepared from a silica supported bisimine pyridine iron catalyst. The nascent product is disentangled and can be thermally densified without loss of its low viscosity.
Adrian Vaghar, Georgij Jegorenkov, Yunus Kutlu, Andreas Ostendorf, Gerrit A. Luinstra   +4 more
wiley   +1 more source

CALPHAD‐Guided Prediction and Interpretation of Phase Formation in Ta–Mo–Cr–Ti–Al Refractory High‐Entropy Alloys

Advanced Engineering Materials, EarlyView.
This study designs Ta–Mo–Cr–Ti–Al refractory high‐entropy alloys with a disordered body‐centered‐cubic A2 crystal structure aiming for improved ductility, lower density, and oxidation resistance. Four alloy compositions are identified by thermodynamic calculations.
Kateryna Khanchych, Chongchong Tang, Carsten Schroer, Björn Schäfer, Judith Jung, Michael Dürrschnabel, Ute Jäntsch, Bronislava Gorr   +7 more
wiley   +1 more source

Reactive Interaction and Wetting of Fe‐ and Mn‐Containing, Secondary AlSi Alloys with Manganese Oxide Ceramic Filter Material for Fe Removal

Advanced Engineering Materials, EarlyView.
Fe‐ and Mn‐containing AlSi alloys undergo aluminothermic reaction with Mn oxide in sessile‐drop and crucible experiments forming poor‐wetting Al2O3 while Mn enriches in the alloy. Primary Fe‐containing particles are preferentially attached to the Mn oxide.
Hanka Becker, Simon Waschull, Beate Fankhänel, Claudia Voigt, Alexandros Charitos, Christos G. Aneziris, Andreas Leineweber   +6 more
wiley   +1 more source