Lead-free and scalable GeTe-based thermoelectric module with an efficiency of 12. [PDF]
Sci Adv, 2023 GeTe-based materials with superior thermoelectric properties promise great potential for waste heat recovery. However, the lack of appropriate diffusion barrier materials (DBMs) limits not only the energy conversion efficiency but also the service ...
Xie L +10 more
europepmc +2 more sources
Prototype fabrication and performance evaluation of a thermoelectric module operating with the Nernst effect. [PDF]
iScience, 2021 Summary The Nernst effect generates a voltage transverse to the temperature gradient in the magnetic field. Although the Nernst effect has the potential to realize novel devices in the field of thermoelectric generators and sensors, thermoelectric ...
Murata M +4 more
europepmc +2 more sources
Fabrication and thermoelectric conversion of thermoelectric concrete brick with buried unileg N-type CaMnO3 thermoelectric module inside [PDF]
Scientific Reports, 2023 To investigate the effect of heat loss reduction due to thermal insulator and thermal interface resistance due to multi-layer structure in order to improve the efficiency of a thermoelectric device, a thermoelectric concrete brick was fabricated using a ...
Keerati Maneesai +6 more
doaj +2 more sources
Characterization System for Heat-Energy to Electric-Energy Conversion from Concrete by Means of a Thermoelectric Module [PDF]
Sensors, 2022 The present work describes the implementation of a prototype to characterize thermoelectric modules (TEM). The goal is to study the energy conversion by means of thermoelectric modules mounted on concrete structures.
Luis C. Félix-Herrán +5 more
doaj +2 more sources
Sensible air cool-warm fan with thermoelectric module systems development
Case Studies in Thermal Engineering, 2019 An experimental investigation on the application of thermoelectric modules for cooling and heating supply air of the conventional fan system is performed.
S. Wiriyasart, P. Naphon, C. Hommalee
doaj +2 more sources
Case Studies in Thermal Engineering, 2019 The thermal efficiency enhancement of thermoelectric module system for cold-hot water dispenser has been continuously performed. In the present study, the water block embedded with heat sink has been designed and simulated to obtain the maximum cooling ...
S. Wiriyasart +4 more
doaj +2 more sources
Modeling and Experimentation of New Thermoelectric Cooler–Thermoelectric Generator Module [PDF]
Energies, 2018 In this work, a modeling and experimental study of a new thermoelectric cooler–thermoelectric generator (TEC-TEG) module is investigated. The studied module is composed of TEC, TEG and total system heatsink, all connected thermally in series.
Khaled Teffah +2 more
doaj +2 more sources
Inconsistent phenomenon of thermoelectric load resistance for photovoltaic–thermoelectric module [PDF]
Energy Conversion and Management, 2018 Abstract Combing PV with Thermoelectric (TE) would be dominant because it can employ the solar fully spectrum to produce electricity. But the TE efficiency is significantly lower than PV efficiency and the coupling effect between them will limit the performance of PV and TE. The analyze and comparison on the different characteristics among the hybrid
Guiqiang Li +4 more
semanticscholar +3 more sources
Quantitative measurements of transverse thermoelectric generation and cooling performances in SmCo5/Bi0.2Sb1.8Te3-based artificially tilted multilayer module [PDF]
Science and Technology of Advanced MaterialsThe transverse thermoelectric generation and cooling performances in a thermopile module composed of recently developed SmCo5/Bi0.2Sb1.8Te3 artificially tilted multilayers are evaluated quantitatively.
Masayuki Murata +4 more
doaj +2 more sources
Energies, 2022 Due to the low efficiency of thermoelectric generators (TEGs), many scholars have focused on the structural optimization of TEGs rather than on the optimization of the layout of thermoelectric modules.
Weiqi Zhou +6 more
doaj +1 more source