Results 71 to 80 of about 40,582 (335)

ANALISA THERMOGRAVIMETRY PADA PEMBAKARAN SAMPAH KOTA

Ethos: Jurnal Penelitian dan Pengabdian kepada Masyarakat, 2016
Penelitian ini dilakukan untuk menemukan karakteristik termal dari pembakaran sampah kota terseleksi melalui metoda thermogravimetry. Langkah pertama dalam penelitian ini adalah melakukan pengumpulan bahan baku terlebih dahulu, yaitu berupa sampah kota ...
Yohanes Parningotan Silaban, Dwi Aries Himawanto, D. Danardono   +2 more
doaj  

Selective Reduction Laser Sintering: A New Strategy for NO2 Gas Detection Based on In2O3 Nanoparticles

Advanced Functional Materials, EarlyView.
This research utilizes selective reduction laser sintering (SRLS) to engineer In2O3 NPs for flexible NO2 sensors. The introduction of oxygen vacancy defects enhances sensor performance, offering excellent responsiveness, rapid response/recovery, superior selectivity, low detection limit, and long‐term stability.
Shaogang Wang, Chunjian Tan, Qihang Zong, Shizhen Li, Chenshan Gao, Huiru Yang, Qianming Huang, Paddy French, Huaiyu Ye   +8 more
wiley   +1 more source

Derivatografic study of the ointment with piroctone olamine for therapy and prevention of seborrheic dermatitis

Aktualʹnì Pitannâ Farmacevtičnoï ì Medičnoï Nauki ta Praktiki, 2020
Piroctone olamine (octopirox) has a wide spectrum of antibacterial activity against gram-positive and gram-negative pathogenic microorganisms together with the expressed antimycotic action.
V. A. Solodovnyk, V. V. Hladyshev, B. S. Burlaka, I. O. Pukhalska   +3 more
doaj   +1 more source

Development of a Novel, All‐Aromatic High Tensile Modulus Liquid Crystalline Polyimide for Fused Filament Fabrication Applications

Advanced Functional Materials, EarlyView.
A novel, high tensile modulus, fully aromatic thermotropic liquid crystalline polyimide (LCPI) with better solvent resistance and thermal stability is synthesized. Tensile specimens are fabricated using both injection molding and FFF processes, accomplished via lower viscosity enabled by the LC phase.
Zhenning Yu, Mia Carrola, Bingqian Zheng, Loon‐Seng Tan, Amir Asadi, Christopher A. Crouse, Hilmar Koerner   +6 more
wiley   +1 more source

Thermooxidative stability of PMMA composites [PDF]

, 2012
Tato práce se zabývá studiem termooxidační stability kompozitů polymethylmethakrylátu (PMMA) plněného mikro a nanočásticemi siliky. V připravených vzorcích byly použity různé objemové zlomky a různé velikosti částic siliky.
Čechová, Eva
core  

Sol–gel synthesis and thermal behavior of bioactive ferrous citrate–silica hybrid materials [PDF]

, 2018
Imbalance of the iron level in the body causes several diseases. In particular, the low level of iron, during pregnancy, is responsible for the iron deficiency anemia, and even of neurodegenerative diseases.
Catauro, M., Naviglio, D., Risoluti, R., Vecchio, Ciprioti   +3 more
core   +1 more source

Switching From Acceptor to FRET Donor: How the Organic Solar Cell Architecture Can Change the Role of a Chromophore

Advanced Functional Materials, EarlyView.
The non‐fullerene acceptor o‐IDT‐BT‐DCV is used in both binary and ternary blends to investigate the role that it plays in each device architecture. The charge generation pathways are found to differ between the binary and ternary blends with o‐IDT‐BT‐DCV becoming a second donor in the ternary blend.
Hui Jin, Neil Mallo, Guanran Zhang, Oliver Lindsay, Ronan Chu, Mile Gao, Shaun McAnally, Isaac M. Etchells, Paul L. Burn, Ian R. Gentle, Paul E. Shaw   +10 more
wiley   +1 more source

Determination of the vapour pressure curves and vaporization enthalpies of hafnium alkoxides using thermogravimetric analysis [PDF]

Royal Society Open Science, 2019
In order to identify a volatile metallo-organic precursor for the deposition of hafnium oxide (HfO2) films for atomic layer deposition (ALD) applications, the evaporative properties of hafnium alkoxides (hafnium isopropoxide, hafnium n-propoxide and ...
Changhong Wang, Shenghai Yang, Yongming Chen   +2 more
doaj   +1 more source

Polymer Brush Growth by Surface‐Initiated Ring‐Opening Polymerization from a Cross‐Linked Polymer Thin Film

Advanced Functional Materials, EarlyView.
A stable cross‐linked ultra‐thin polymer coating for surface‐initiated ring‐opening polymerization (SI‐ROP) of hexamethylcyclotrisiloxane and ε‐caprolactone for growth of high grafting density poly(dimethyl siloxane) and poly(caprolactone) brushes is developed.
Miguel Betancourt‐Ponce, Bharathan Govindarajan, Jacob Pike, Padma Gopalan   +3 more
wiley   +1 more source

Synthesis, characterization and thermogravimetric study of Cu(II) adducts with 3- and 4-amino-1,2,4-triazole, 2-mercaptothiazoline and 2-mercaptopyridine [PDF]

Journal of the Serbian Chemical Society, 2006
The adducts CuCl2·(3amt), CuCl2·2(3amt)·2H2O, CuCl2·3(3amt), CuCl2·(4amt), CuCl2·2(4amt), CuCl2·3(4amt)·2H2O, CuCl2·(2mct)·H2O, CuCl2·2(2mct)·2.5H2O, CuCl2·3(2mct)·2H2O, CuCl2·(2mcp) and CuCl2·2(2mcp)·H2O, where 3-amino-1,2,4-triazole = 3amt, 4-amino-1,2,
Refat Moamen S., de Farias Robson F.
doaj   +1 more source