Polarized neutron channeling as a tool for the investigations of weakly magnetic thin films
, 2015 We present and apply a new method to measure directly weak magnetization in thin films. The polarization of a neutron beam channeling through a thin film structure is measured after exiting the structure edge as a microbeam. We have applied the method to
Keller, T. +4 more
core +1 more source
Anomalous absorption of bulk shear sagittal acoustic waves in a layered structure with viscous fluid [PDF]
, 2003 It is demonstrated theoretically that the absorptivity of bulk shear sagittal waves by an ultra-thin layer of viscous fluid between two different elastic media has a strong maximum (in some cases as good as 100%) at an optimal layer thickness.
Baik +29 more
core +3 more sources
Thin-layer chromatography of the phosphoinositides
Journal of Lipid Research, 1968 Thin-layer chromatography for the separation of mono-, di-, and triphosphoinositides (0.3-3 micro g total phosphorus) is described.
F. Gonzalez-Sastre +3 more
openaire +4 more sources
Thin Shell Dynamics and Equations of State [PDF]
Phys.Rev.D78:044003,2008, 2008 A relation between stress-energy and motion is derived for accelerated Israel layers. The relation, for layers between two Schwarzschild manifolds, generalizes the equation of state for geodesic collapse. A set of linked layers is discussed.
arxiv +1 more source
Convective Air Drying Characteristics for Thin Layer Carrots
, 2013 Introduction : Carrot is one of the most commonly used vegetables for human nutrition due to high vitamin and fibre content. Drying is one of the oldest methods of food preservation, and it represents a very important aspect of food processing.
I. Veleșcu +3 more
semanticscholar +1 more source
Growth of Epitaxial Oxide Thin Films on Graphene [PDF]
, 2016 The transfer process of graphene onto the surface of oxide substrates is well known. However, for many devices, we require high quality oxide thin films on the surface of graphene. This step is not understood.
Alford, N +8 more
core +1 more source
Characterization of Ag-Cu-S Thin Layers Formed on Low Density Polyethylene Film
Medžiagotyra, 2011 The Ag-Cu-S layer formed on PE demonstrated a wide variation in thickness. The cross-section showed the average thickness of sulfide layers on PE increase from 1.9 mm to 5.6 mm with the increase in the sulfurization time and from 1.9 mm to
Ingrida ANCUTIENĖ +2 more
doaj +1 more source
Influence of homo-buffer layer on stress control of sputtered (Ba0.45,Sr0.55)TiO3 thin films on Pt-Si [PDF]
arXiv, 2013 To engineer strain relaxation of sputtered BST thin films on Pt-Si wafers, homo-buffer layer method was applied to eliminate Pt hillock formation. Thin BST homo-buffer layers were deposited at room temperature and subsequently the main BST layer was deposited at 650{\deg}C, Pt hillock free BST films were obtained with homo-buffer thickness above 5 nm ...
arxiv
Effects of resonances and surface texturing on light emission in emerging thin-film devices [PDF]
Proc. SPIE 12880, 128800N (2024)Recent developments in thin-film fabrication and processing open up interesting possibilities for both established and emerging optics technologies. There, one of the key questions requiring more complete understanding is by how much one can improve the performance of thin-film devices by utilizing resonance effects and surface texturation.
arxiv +1 more source
Dimensional transition of energy cascades in stably stratified thin fluid layers [PDF]
, 2014 Numerical simulations of a thin layer of turbulent flow in stably stratified conditions within the Boussinesq approximation have been performed. The statistics of energy transfer among scales have been investigated for different values of control parameters: thickness of the layer and density stratification.
arxiv +1 more source