Results 121 to 130 of about 265,797 (310)
A comparison of double sided friction stir welding in air and underwater for 6mm S275 steel plate
, 2014 This study compared the mechanical and microstructural properties produced during friction stir welding (FSW) of S275 structural steel in air and underwater.
Baillie, Philip +9 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer +4 more
wiley +1 more source
Applied SciencesThe water-flowing fractured zone development height (WFZDH) is of great importance for water prevention and control in coal mines. The purpose of this research is to obtain a WFZDH prediction method of the first mining face based on thin plate theory ...
Fengfeng Wu +4 more
doaj +1 more source
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source
Thin-Plate Superstructures of the Immunogenic 33-mer Gliadin Peptide. [PDF]
Chembiochem, 2022 Herrera MG +6 more
europepmc +1 more source
ON THE ELASTODYNAMICS OF THIN MICROPERIODIC PLATES
, 1995 The aim of this paper is to propose and investigate a new modelling approach to thin elastic plates having micro-periodic structure in planes parallel to the midplane. The main feature of this approach is that it describes the effect of the microstructure length dimensions on the macro-behaviour of the plate.
Jȩdrysiak, Jarosław +1 more
openaire +2 more sources
Analysis of the machining stability in milling thin-walled plate
, 2015 The thin-walled plate parts are widely used in the aeronautical industry. Research on the machining stability in end milling of thin-walled plate is of great significance to improve the materials remove rates and optimize milling parameters.
Qu S(曲胜) +2 more
core
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Fabricating Inner Channels in Laser Additive Manufacturing Process via Thin-Plate-Preplacing Method. [PDF]
Materials (Basel), 2023 Jiao J +5 more
europepmc +1 more source
Design and Analysis of Compression–Torsion Coupling Metamaterials Using the Golden Section Method
Advanced Engineering Materials, EarlyView.A novel compression–torsion metamaterial is engineered using inclined rods and symmetry breaking. To optimize its torsional performance, the golden section method is employed. The mechanical response of the metamaterial is validated through both numerical analysis and experimental validation.
Amirhossein Hassani, Sara Bagherifard
wiley +1 more source