Results 111 to 120 of about 165,542 (311)
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Applications of Modelling and Simulation, 2021 Through the means of finite element analysis, J-integral for a straight through-thickness crack has been consistently reported to decrease along the crack front with the maximum and minimum values are at the midplane and the free-surface, respectively ...
Norwahida Yusoff, Feizal Yusof
doaj
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Developments in the Built EnvironmentConventional close stirrup has been widely used in RC beams to avoid shear failure behavior but the effect of internal vertical stirrup legs on the shear strength and the initiation of three-dimensional diagonal shear crack in RC beams is still debatable.
Muhammad Abdullah +2 more
doaj +1 more source
ZIP3D: An elastic and elastic-plastic finite-element analysis program for cracked bodies [PDF]
ZIP3D is an elastic and an elastic-plastic finite element program to analyze cracks in three dimensional solids. The program may also be used to analyze uncracked bodies or multi-body problems involving contacting surfaces.
Newman, J. C., Jr., Shivakumar, K. N.
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
Finite element models for predicting crack growth characteristics in composite materials [PDF]
Two dimensional and quasi-three dimensional, linear elastic finite element models for the prediction of crack growth characteristics, including crack growth direction, in laminated composite materials are presented.
Buczek, M. B., Herakovich, C. T.
core +1 more source
A general boundary-only formula for crack shape sensitivity of integral functionals.
, 1999 This note presents, in the framework of three-dimensional linear elastodynamics in the time domain, a method for evaluating sensitivities of integral functionals to crack shapes, based on the adjoint state approach and resulting in a sensitivity formula ...
Bonnet, Marc
core +4 more sources