Results 201 to 210 of about 74,255 (306)

Performance measurement of high gain Landsman converter with ANFIS based MPPT and cascaded H-bridge thirty-one multilevel inverter in a single-phase grid-connected PV system. [PDF]

Sci Rep
Kumar NB, M UMR, Lakshminarayana P, Rao CNN, Veeranjaneyulu J.   +4 more
europepmc   +1 more source

Exploiting Two‐Photon Lithography, Deposition, and Processing to Realize Complex 3D Magnetic Nanostructures

Advanced Functional Materials, EarlyView.
Two‐photon lithography (TPL) enables 3D magnetic nanostructures with unmatched freedom in geometry and material choice. Advances in voxel control, deposition, and functionalization open pathways to artificial spin ices, racetracks, microrobots, and a number of additional technological applications.
Joseph Askey, Arjen van den Berg, Sandra Ruiz Gomez, Claire Donnelly, Dirk Grundler, Sam Ladak   +5 more
wiley   +1 more source

Data-driven dynamic modeling for inverter-based resources using neural networks. [PDF]

Nat Commun
Yang K, Wang X, Chen X, Wang R, Geng G, Jiang Q.   +5 more
europepmc   +1 more source

Hydrogen‐Bond‐Rich Supramolecular Multiblock Copolymers Facilitate Rapid Zn2+ Migration in Quasi‐Solid‐State Zinc‐Ion Batteries

Advanced Functional Materials, EarlyView.
The disordered growth of dendrites, corrosion, parasitic side reactions, slow de‐solvation kinetics, and inherent safety risks significantly hinder the practical deployment of conventional liquid electrolyte zinc‐ion batteries. In contrast, the novel PU‐EG+DMPA‐Zn polyurethane quasi‐solid‐state electrolyte, enriched with abundant polar functional ...
Ruiqi Liu, Changding Wang, Fu Wan, Kaida Hu, Da Yang, Yaoyang Xia, Wenwei Yin, Yupeng Lin, Yuejiao Chen, Shuhui Sun, Weigen Chen   +10 more
wiley   +1 more source

Whale optimization-based fractional order control for high-performance grid-connected photovoltaic multilevel inverters: diode-clamped versus T-type MLIs. [PDF]

Sci Rep
Djellad A, Dekhane A, Farhat M, Takruri M, Al-Qaisi A.   +4 more
europepmc   +1 more source

Microsphere Autolithography—A Scalable Approach for Arbitrary Patterning of Dielectric Spheres

Advanced Functional Materials, EarlyView.
MicroSphere Autolithography (µSAL) enables scalable fabrication of patchy particles with customizable surface motifs. Focusing light through dielectric microspheres creates well defined, tunable patches via a conformal poly(dopamine) photoresist. Nearly arbitrary surface patterns can be achieved, with the resolution set by the index contrast between ...
Elliott D. Kunkel, Alec G. Burnett, Katherine E. Scheiber, Hans D. Robinson   +3 more
wiley   +1 more source

Single-Switch Inverter Modular Parallel Multi-Voltage Levels Wireless Charging System for Robots. [PDF]

Sensors (Basel)
Li H, Sun Z, Wei L.
europepmc   +1 more source

Quantifying Spin Defect Density in hBN via Raman and Photoluminescence Analysis

Advanced Functional Materials, EarlyView.
An all‐optical method is presented for quantifying the density of boron vacancy spin defects in hexagonal boron nitride (hBN). By correlating Raman and photoluminescence signals with irradiation fluence, defect‐induced Raman modes are identified and established an relationship linking optical signatures to absolute defect densities. This enables direct
Atanu Patra, Paul Konrad, Andreas Sperlich, Timur Biktagirov, Wolf Gero Schmidt, Lesley Spencer, Igor Aharonovich, Sven Höfling, Vladimir Dyakonov   +8 more
wiley   +1 more source

Enhancing microgrid resilience through integrated grid-forming and grid-following inverter strategies for solar PV battery control and fault ride-through. [PDF]

Sci Rep
Hossain MI, Anonto HZ, Shufian A, Pathik BB, Mannan MA, Rashid A, Biswas P.   +6 more
europepmc   +1 more source

High‐Rate FA‐Based Co‐Evaporated Perovskites: Understanding Rate Limitations and Practical Considerations to Overcome Their Impact

Advanced Functional Materials, EarlyView.
Vacuum‐based deposition is promising for perovskite solar cells to be successfully commercialized. However, co‐evaporation, the most common vapor phase deposition technique, suffers from very low deposition rates. In this work, we reveal that high deposition rates can lead to carbon flakes depositing into the perovskite absorber layers due to material ...
Thomas Feeney, Aleksandra Miaskiewicz, Julian Petry, Felix Laufer, Roja Singh, Stefanie Severin, Viktor Škorjanc, Alexander Diercks, Suresh Maniyarasu, Lars Korte, Steve Albrecht, Ulrich W. Paetzold, Marcel Roß, Paul Fassl   +13 more
wiley   +1 more source