Results 101 to 110 of about 21,811 (169)

In Situ Change in Contact Angle of a Sessile Droplet on a Magnetoactive Elastomer

open access: yesAdvanced Materials Interfaces, EarlyView.
Contact angles of persistent μL$\mu{\rm L}$‐sized water droplets on a mechanically soft MAE surface under time varying magnetic fields differ from those of newly deposited droplets. The ability to quickly alter the material properties allows one to observe intriguing droplet‐material interactions.
Raphael Kriegl   +3 more
wiley   +1 more source

Low‐Temperature Gold Deposition Improves CdTe Back Contacts

open access: yesAdvanced Materials Interfaces, EarlyView.
Cd(Se,Te) samples are cooled during the evaporation of Au back contacts to thermally quench CdTe degradation. Reduced temperature during Au evaporation boosts PV efficiency, open‐circuit voltage, and fill factor. XPS associates these improvements with less chemical perturbation of the CdTe surface during metallization.
Christopher P. Muzzillo   +5 more
wiley   +1 more source

From the Discovery of the Giant Magnetocaloric Effect to the Development of High‐Power‐Density Systems

open access: yesAdvanced Materials Technologies, EarlyView.
The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz   +5 more
wiley   +1 more source

The routine use of nasopharyngeal airway in the setting of monitored anesthesia care during gastrointestinal endoscopy: A multi-center single blinded randomized controlled trial. [PDF]

open access: yesPLoS One
Raphael C   +10 more
europepmc   +1 more source

Fully Printed Electrocaloric Heat Pump

open access: yesAdvanced Materials Technologies, EarlyView.
A system based on a flexible printed PEDOT:PSS/P(VDF‐TrFE‐CFE) electrocaloric membrane. The membrane periodically alternates between the cold and hot sides following its electrocaloric cycle and successfully generates a temperature difference. The entire fabrication process is industrially scalable, cost‐effective, and based on widely accessible ...
Adrian Agreda   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy