Evaluation of Ti-6Al-4V surface treatments for use with a polyphenylquinoxaline adhesive [PDF]
Three surface treatments for Ti-6Al-4V adherends were evaluated using a thermoplastic polymer monoether polyphenylquinoxaline, MEPPQ, which had been shown in previous studies to have good potential as a high temperature adhesive for aerospace ...
Progar, D. J.
core +1 more source
Effect of creep in titanium alloy Ti-6Al-4V at elevated temperature on aircraft design and flight test [PDF]
Short-term compressive creep tests were conducted on three titanium alloy Ti-6Al-4V coupons at three different stress levels at a temperature of 714 K (825 F).
Jenkins, J. M.
core +1 more source
On the measurement of dimensional quality of titanium alloy micro lattice struts manufactured using selective laser melting [PDF]
, 2015 The paper describes the measurement of the surface quality, dimensional accuracy, and cross sectional circularity of titanium alloy ( Ti-6Al-4V ) micro struts manufactured using selective laser melting.
Hasan, Rafidah, Mines, Bob
core
Enhanced cell adhesion and proliferation on dual plasma modified titanium surfaces [PDF]
, 2010 Session: Biomaterials Fabrication and Synthesis: abstract no. 47INTRODUCTION: Ti-6Al-4V is widely used in present orthopedic applications, owing to a combination of good mechanical properties and excellent corrosion resistance. However, long-term success
Chu, PK +4 more
core
Ultrasonic treatment with nickel electroplating combined with oxidation for developing γ-Al2O3 washcoat on Fe-Cr-Al substrate [PDF]
, 2012 Fe-Cr-Al is used as metallic support for catalytic converter due to its high thermal conductivity, lower heat capacity, high temperature and mechanical shock resistance. γ-Al2O3 is the most widely used material as washcoat which embedded on metallic
Firdianto, Ade
core
Evaluation of a thermoplastic polyimide (422) for bonding GR/PI composite [PDF]
A hot-melt processable copolyimide previously studied and characterized as an adhesive for bonding Ti-6Al-4V was used to bond Celion 6000/LARC-160 composite. Comparisons are made for the two adherend systems.
Progar, Donald J.
core +1 more source
Fatigue behavior of SiC reinforced titanium composites [PDF]
The low cycle axial fatigue properties of 25 and 44 fiber volume percent SiC/Ti(6Al-4V) composites were measured at room temperature and at 650 deg C. The S-N curves for the composites showed no anticipated improvement over bulk matrix behavior at room ...
Bhatt, R. T., Grimes, H. H.
core +1 more source
Compatibility testing of spacecraft materials and spacestorable liquid propellants [PDF]
Compatibility data for aluminum alloy 2219-T87 and titanium alloy Ti-6Al-4V were obtained while these alloys were exposed to both liquid and vapor fluorine and FLOX at -320 F + or -10 F.
Denson, J. R., Toy, A.
core +1 more source
Sustained load crack growth design data for Ti-6Al-4V titanium alloy tanks containing hydrazine [PDF]
Sustained load crack growth data for Ti-6Al-4V titanium alloy in hydrazine per MIL-P-26536 and refined hydrazine are presented. Fracture mechanics data on crack growth thresholds for heat-treated forgings, aged and unaged welds, and aged and unaged heat ...
Kenny, J. T., Lewis, J. C.
core +1 more source