Results 71 to 80 of about 431,487 (289)
International Journal of Nanomedicine, 2020 Yan Gao,1 Xi Lin,1 Yadong Zhao,2 Shulan Xu,1 Chunhua Lai,1 Zehong Guo,1 Wangxi Wu,1 Xianglong Ding,1 Fang Jia,1 Lei Zhou,1 Ying Liu3 1Center of Oral Implantology, Stomatological Hospital, Southern Medical University, Guangzhou 510280, People’s ...
Gao Y +10 more
doaj
Jurnal Riset Kimia, 2023 Mn (II) is a metal ion commonly used in steel alloys, pigment industries, welding, fertilizers, pesticides, ceramics, and electronics. According to the Regulation of the Minister of Health No.
Ana Hidayati Mukaromah +3 more
doaj +1 more source
Chemical Vapor Deposition of silicon nanodots on TiO2 submicronic powders in vibrated fluidized bed [PDF]
, 2010 Silicon nanodots have been deposited on TiO2 submicronic powders in a vibrated Fluidized Bed Chemical Vapor Deposition (FBCVD) reactor from silane SiH4. Deposition conditions involving very low deposition rates have been studied. After treatment, powders
Cadoret, Loic +3 more
core +3 more sources
Advanced Engineering Materials, EarlyView.A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source
Production of Nanosized Synthetic Rutile from Ilmenite Concentrate by Sonochemical HCl and H2SO4 Leaching [PDF]
Iranian Journal of Chemistry & Chemical Engineering, 2014 Titanium dioxide is widely used in the manufacturing of paints, varnishes, lacquer, paper, paperboard, printing inks, rubber, floor covering, and ceramics and so on. White titanium dioxide pigment has been produced by two main processes.
Razieh Razavi +2 more
doaj
Revista de Metalurgia, 2018 La tasa de osteointegración de los implantes, entre otros factores, depende de la topografía y de la composición química de la superficie, así como de las interacciones entre la superficie del implante y las células.
Joan Lario +3 more
doaj +1 more source
Electrochemical and photo-electrochemical processes of Methylene blue oxidation by Ti/TiO2 electrodes modified with Fe-allophane [PDF]
, 2017 Indexación: Scopus.This work reports the degradation of methylene blue (MB) on Ti/TiO2 and Ti/TiO2/Fe-allophane electrodes in a pH 3 using 0.1 M Na2SO4 as support electrolyte.
Berríos, C. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.Collagen hydrolysate is evaluated as a sustainable binder for MgO‐C refractories. Its thermally induced cross‐linking and gas release lead to expansion and cracking in large bricks, but tailored batches with lignin, recyclates, or fine graphite improve the gas release while thermal treatment and stability.
Till M. J. Stadtmüller +8 more
wiley +1 more source
Photocatalytic activity of graphene oxide–TiO2 thin films sensitized by natural dyes extracted from Bactris guineensis [PDF]
Royal Society Open Science, 2019 This study synthesized and characterized composites of graphene oxide and TiO2 (GO–TiO2). GO–TiO2 thin films were deposited using the doctor blade technique.
William Vallejo +4 more
doaj +1 more source
Layer-Resolved Ultrafast XUV Measurement of Hole Transport in a Ni-TiO2-Si Photoanode [PDF]
, 2019 Metal-oxide-semiconductor junctions are central to most electronic and optoelectronic devices. Here, the element-specificity of broadband extreme ultraviolet (XUV) ultrafast pulses is used to measure the charge transport and recombination kinetics in ...
Cushing, Scott K. +7 more
core +3 more sources