Results 1 to 10 of about 47,273 (234)
The Role of Substrate Surface Geometry in the Photo-Electrochemical Behaviour of Supported TiO2 Nanotube Arrays: A Study Using Electrochemical Impedance Spectroscopy (EIS). [PDF]
Molecules, 2023 Highly ordered TiO2 nanotube (NT) arrays grown on Ti mesh and Ti foil were successfully prepared by a controlled anodic oxidation process and tested for water photo-electrolysis.
De Pasquale L +7 more
europepmc +2 more sources
Highly Ordered TiO2 Nanotube Arrays with Engineered Electrochemical Energy Storage Performances. [PDF]
Materials (Basel), 2021 Nanoscale engineering of regular structured materials is immensely demanded in various scientific areas. In this work, vertically oriented TiO2 nanotube arrays were grown by self-organizing electrochemical anodization.
Cao W, Chen K, Xue D.
europepmc +2 more sources
TiO2 nanotube arrays with visible light catalytic
Anais da Academia Brasileira de Ciências, 2023 The TiO2 nanotube arrays were prepared by anodization, and the crystal structure was changed by calcination at different temperatures. The photocatalytic performance of the samples was measured by the degradation of rhodamine B under visible light.
ENYANG LIU, XIAOJIAN BI
doaj +4 more sources
An Important Factor Affecting the Supercapacitive Properties of Hydrogenated TiO2 Nanotube Arrays: Crystal Structure [PDF]
Nanoscale Research Letters, 2019 Employing a suitable crystal structure can significantly modify the electrochemical performances of materials. Herein, hydrogenated TiO2 nanotube arrays with orientation and different rutile/anatase ratio were fabricated via anodisation, high ...
Wenyi Li +5 more
doaj +2 more sources
Effects of NH4F and distilled water on structure of pores in TiO2 nanotube arrays [PDF]
Scientific Reports, 2018 In this study, we report the influences of distilled water and ammonium fluoride (NH4F) on morphology of pores in honeycomb-like titanium dioxide (TiO2) nanotube arrays. We observed the structure and arrangement of pores in the TiO2 nanotube arrays based
Jaegyu Kim +7 more
doaj +2 more sources
Frontiers in Chemistry, 2022 Three-dimensional surface-enhanced Raman scattering (SERS) substrates usually provide more hot spots in the excitation light beam and higher sensitivity when compared with the two-dimensional counterpart.
Haichao Zhai +4 more
doaj +1 more source
Catalysts, 2021 Biochar nanoparticles (BC NPs), produced by low temperature pyrolysis (350 °C) of microalgae (Nannochloropsis sp.) and nutshells, are proposed as low-cost and sustainable co-catalysts to promote the photocatalytic activity of TiO2 nanotube (NT) arrays ...
M. Pinna +7 more
semanticscholar +1 more source
Electrochemistry Communications, 2022 The feasibility of electrochemical detection of 2,4,6-trinitrotoluene (2,4,6-TNT) using TiO2 nanotubes synthesized through electrochemical anodization of Ti was explored.
Sanghyeon Moon +4 more
doaj +1 more source
Fabrication of TiO2-Nanotube-Array-Based Supercapacitors [PDF]
Micromachines, 2019 In this work, a simple and cost-effective electrochemical anodization technique was adopted to rapidly grow TiO2 nanotube arrays on a Ti current collector and to utilize the synthesized materials as potential electrodes for supercapacitors. To accelerate the growth of the TiO2 nanotube arrays, lactic acid was used as an electrolyte additive.
Faheem Ahmed +6 more
openaire +5 more sources
Nanomaterials, 2017 Dye-sensitized solar cells (DSSCs) were fabricated with closed- or open-ended freestanding TiO2 nanotube arrays as photoelectrodes that were decorated with carbon materials and large TiO2 nanoparticles (NPs) to enhance energy conversion efficiency.
Won-Yeop Rho +3 more
doaj +1 more source