Results 271 to 280 of about 56,271 (309)
Some of the next articles are maybe not open access.
Surface Science Spectra, 1994
The Auger electron spectra for titanium carbide are presented. The first derivative Auger electron spectrum for the C KLL line is characteristic of a carbide. The differentiated C KLL peak contains three components present at the approximate kinetic energies of 250, 260, and 270 eV, with the peak at 270 eV having a greater intensity in the positive ...
openaire +1 more source
The Auger electron spectra for titanium carbide are presented. The first derivative Auger electron spectrum for the C KLL line is characteristic of a carbide. The differentiated C KLL peak contains three components present at the approximate kinetic energies of 250, 260, and 270 eV, with the peak at 270 eV having a greater intensity in the positive ...
openaire +1 more source
Titanium Nitride and Titanium Carbide as Semiconductors
Nature, 1954IT is well known that titanium nitride shows the electric properties of a typical metal1. In fact, the specific resistivity ρ is lower than that of titanium metal itself. We have re-examined these experiments, using van Arkels's technique2 of deposition from the vapour phase for the preparation.
A. MÜNSTER, K. SAGEL, G. SCHLAMP
openaire +1 more source
Structural characterisation of titanium silicon carbide reaction
Microelectronic Engineering, 2001Abstract Interfacial reaction and phase formation as a function of annealing temperature (900, 950 and 1000°C) and times were investigated on titanium thin films evaporated on n-type 6H-SiC (0001) substrate. The study was carried out employing a combination of Rutherford backscattering spectrometry, X-ray diffraction and sheet resistance measurements.
A. MAKTHARI +4 more
openaire +4 more sources
Production of titanium carbide powder from titanium swarf
Soviet Powder Metallurgy and Metal Ceramics, 1983It is demonstrated that titanium carbide powder can be obtained from titanium swarf. The following optimum parameters of carbidization in a vacuum corresponding to 0.013 Pa have been established: 1.5-h holding at a temperature of 1873°K; 0.5-h holding at 2273°K; 0.5-h comminution in a vibratory mill; and 0.5-h holding at 2273°K, The amount of oxygen in
S. S. Kiparisov +3 more
openaire +1 more source
Journal of the American Ceramic Society, 1964
The thermal conductivity of titanium carbide, zirconium carbide, and titanium nitride was measured by a variety of techniques in the temperature range 200° to 2000° C. The titanium nitride results are a factor of four higher than the previously published values at 1000°C and show a positive temperature coefficient for the thermal conductivity rather ...
R. E. TAYLOR, J. MORREALE
openaire +1 more source
The thermal conductivity of titanium carbide, zirconium carbide, and titanium nitride was measured by a variety of techniques in the temperature range 200° to 2000° C. The titanium nitride results are a factor of four higher than the previously published values at 1000°C and show a positive temperature coefficient for the thermal conductivity rather ...
R. E. TAYLOR, J. MORREALE
openaire +1 more source
Microfrictional Properties of Titanium Carbide
MRS Proceedings, 2003ABSTRACTThe tribological issues associated with silicon-based microelectromechanical systems (MEMS) are well known. A popular solution to improve the tribological behavior is to apply different kinds of thin films. One film material, shown to have favorable properties in specialty applications, and which may also be suited for MEMS, is titanium carbide
Syed Imad-Uddin Ahmed +2 more
openaire +1 more source
Oxygen diffusion in titanium carbide
Solid State Ionics, 1984The diffusion coefficients of oxygen were measured in TiC0.97 single crystals by a gas exchange technique in which the amount of stable isotope taken up by the carbide was controlled by introducing a constant gas volume of oxygen-marked carbon monoxide. Diffusion was extended over depths of 1 to 150 μm.
M SCHUHMACHER, P EVENO
openaire +1 more source
Synthesis of Titanium Silicon Carbide
Journal of the American Ceramic Society, 1995Synthesis of bulk titanium silicon carbide (Ti 3 SiC 2 ) from the elemental Ti, Si, and C powders has been accomplished for the first time, using the arc‐melting and annealing route. The effects of various parameters on the phase purity of the Ti
Sowmya Arunajatesan, Altaf H. Carim
openaire +1 more source
Reactive processing of titanium carbide with titanium
Journal of Materials Science, 1984Candace Jo Quinn, David L. Kohlstedt
openaire +2 more sources

